2011-000002 datasheet(9/43 Pages) SAMSUNG

9 / 43 page

3-1-1 Removing the Stand

1. With a pad beneath it, stand the monitor on its

front with the screen facing downward and

the base close to you. Make sure nothing will

damage the screen.

2. Remove the 4 screws on the Stand.

Caution: Be careful. The signal cable and

power cable are still attached to the

monitor.

3. Disconnect the Signal Cable and Power Cord.

3-1-2 Main Body Disassembly

1. Remove 2 screws on the Rear Cover.

2. Pull the Rear Cover up and off the monitor.

3. Remove 15 screws on the PCB Shield and

remove the Shield.

4. Remove 4 screws on the Main PCB and 2

screws on the Inverter PCB and 2 screws on

the 10P Harness.

5. Disconnect the interface wire (31P) between

the Panel and the CN601 connector on the

Main PCB.

6. Disconnect the Function PCB wire (10P)

between the Function PCB and the CN102

connector on the Main PCB.

7. Disconnect 2 Inverter wires between the Panel

and the CN2, 3 connectors on the Inverter PCB

and disconnect the 12P harness between CN1

connector on the inverter and CN103

connector on the Main PCB.

8. Carefully lift the Main PCB Assembly and

Inverter PCB and place them on a flat, level

surface that is protected from static electricity.

9. Remove 4 screws on the PCB Bracket.

10. Remove the Bracket Assembly from the Front

Cover.

11. Remove the 3 screws on the Function PCB

from the Front Cover and remove the

Function PCB and Function Knob.

12. Remove 4 screws on the Front Shield and

remove the PCB Bracket and the Front Shield.

SyncMaster 770TFT

3-1

3 Disassembly and Reassembly

This section of the service manual describes the disassembly and reassembly procedures for the

SyncMaster 770TFT TFT-LCD monitors.

WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling

these components.

3-1 Disassembly

Cautions:1. Disconnect the monitor from the power source before disassembly.

2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.

3-2 Reassembly

Reassembly procedures are in the reverse order of Disassembly procedures.

2011-000002 датащи(PDF) 9 Page - Samsung semiconductor

2011-000002 датащи(HTML) 9 Page - Samsung semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

датащи скачать

ссылки URL