CLC031 datasheet(30/31 Pages) NSC

30 / 31 page

Application Information (Continued)

The control voltage output from R

BB is externally filtered by

the loop filter consisting of a 22.1k

Ω resistor in series with a

10nF capacitor, combined in parallel with a 100pF capacitor.

This gives a loop bandwidth of 1.5kHz. Since the control

voltage is limited to around 2.1V, it requires a level shifter to

get the entire pull range on the VCXO. National’s LMC7101

is recommended with 100k

Ω and 182kΩ resistors as shown

in Figure 7 to provide a gain of 1.55, sufficient to drive a 3.3V

VCXO.

Recommended VCXOs from SaRonix (141 Jefferson Drive,

Menlo Park, CA 94025, USA) include the ST1308AAB-74.25

for high definition and the ST1307BAB-27.00 for standard

definition. Dual VCXOs require some supporting logic to

select the appropriate VCXO. This requires the use of For-

mat[4] (SD/HD) and Lock Detect, which are mapped at

power-on to I/O Port Bit 3 and I/O Port Bit 4, respectively.

These two signals pass through an AND gate (Fairchild

Semiconductor’s NC7SZ08 or similar). Its output is high

when both Lock Detect and Format[4] are high, which indi-

cates a valid high-definition signal is present. The VCXOs

are buffered to control the transition times and to allow easy

selection. The output of the AND gate is used to control the

Output Enable (OE) function of the buffers. The 74.25MHz

VCXO is buffered with the NC7SZ126 with the AND gate

output connected to the OE pin of the NC7SZ126, and the

27.00MHz VCXO is buffered with the NC7SZ125 with the

AND gate output connected to the OE pin of the NC7SZ125.

This circuit uses the 27.00MHz VCXO as default and en-

ables the 74.25MHz VCXO when a valid high-definition sig-

nal is present. The outputs from the buffers are daisy-

chained together and sent to the CLC031’s V

CLK in addition

to other devices, such as the CLC030 serializer.

20020114

FIGURE 7. Using Dual VCXOs for VCLK Example

CLC031 датащи(PDF) 30 Page - National Semiconductor (TI)