30

www.ittcannon.com

Dimensions shown in mm

Specifications and dimensions subject to change

Snap-Lock Environmentally Sealed - Rectangular

Hand Crimp Tool Operation

Cannon SLE

Hand Crimp Tool - CCT - SLC / SLE

Part Number: 995-0002-232

The CCT-SLC/SLE hand crimp tool is designed to crimp individual SLC/SLE contacts on wire sizes 16, 18, and 20 AWG.

Each cycle is ratchet-controlled (The tool must be completely closed before it can be reopened) to assure a satisfactory

crimp each time. Over and under crimps are eliminated.

This tool is for use when the requirement is for low to moderate volume quantities, and for on-site applications where semi-

automatic tools cannot be practically used.

1. Cycle the CCT - SLE / SLC hand tool to the open

position.

2. While pressing upward on the locator spring, insert

the contact with tails upward completely into the

locator.

3. When correctly positioned the contact should be

located beyond flush with the edge of the CCT - SLE

/ SLC and positioned in the concave polished split

level crimp.

4. Partially (usually the first click) Cycle the hand tool

assuring that the upward thrusting tails of the contact

has started engaging with the top jaw of the tool.

(There is a slight tendency for the contact to roll out

of vertical alignment.)

5. Insert the pre-stripped wire into the crimp area of

the contact and completely cycle the tool.

7. The result will be a perfect termination.

8. Note that there are no unterminated wire strands,

and that some strand ends can be seen at the

forward edge of the crimp. Also note the insulation is

gripped by the smaller secondary crimp. Distortion is

at a minimum, both axially and laterally - no sharp

edges.

6. While pressing upward on the locator spring

withdraw the crimp termination.

Wire Stripping

5 and 13 A Contact

Tolerance

A

B

Low

2,41 (.095)

5,33 (.210)

High

3,30 (.130)

5,59 (.220)