PicoScope® 5000D Series oscilloscopes

PicoScope 5000D Series

Technical Specifications

PicoScope 5242D

and 5242D MSO

2-channel, 60 MHz

PicoScope 5442D

and 5442D MSO

4-channel, 60 MHz

PicoScope 5243D

and 5243D MSO

2-channel, 100 MHz

PicoScope 5443D

and 5443D MSO

4-channel, 100 MHz

PicoScope 5244D

and 5244D MSO

2-channel, 200 MHz

PicoScope 5444D

and 5444D MSO

4-channel, 200 MHz

Maximum post-trigger delay

Zero to 4 billion samples, settable in 1 sample steps (delay range on fastest timebase of 0 to 4 s in 1 ns steps)

Trigger rearm time

8-bit mode, typical:

1 μs on fastest timebase

8 to 12-bit modes:

< 2 μs max on fastest timebase

14 to 16-bit modes:

< 3 μs max on fastest timebase

Maximum trigger rate

10 000 waveforms in a 10 ms burst, 8-bit mode

External trigger input – not MSO models

Connector type

Front panel BNC(f)

Trigger types

Edge, pulse width, dropout, interval, logic

Input characteristics

1 MΩ ±1% || 14 pF ±1.5 pF

Bandwidth

60 MHz

100 MHz

200 MHz

Threshold range

±5 V

External trigger threshold accuracy ±1% of full scale

External trigger sensitivity

200 mV peak to peak

Coupling

DC

Overvoltage protection

±100 V (DC + AC peak)

Function generator

Standard output signals

Sine, square, triangle, DC voltage, ramp up, ramp down, sinc, Gaussian, half-sine

Pseudorandom output signals

White noise, selectable amplitude and offset within output voltage range.

Pseudorandom binary sequence (PRBS), selectable high and low levels within output voltage range, selectable bit rate up to 20 Mb/s

Output frequency

0.025 Hz to 20 MHz

Sweep modes

Up, down, dual with selectable start / stop frequencies and increments

Triggering

Can trigger a counted number of waveform cycles or frequency sweeps (from 1 to 1 billion) from the scope trigger, external trigger (non-MSO

models only) or from software. Can also use the external trigger to gate the signal generator output.

Output frequency accuracy

Oscilloscope timebase accuracy ± output frequency resolution

Output frequency resolution

< 0.025 Hz

Output voltage range

±2 V

Output voltage adjustments

Signal amplitude and offset adjustable in approx 0.25 mV steps within overall ±2 V range

Amplitude flatness

< 1.5 dB to 20 MHz, typical

DC accuracy

±1% of full scale

SFDR

> 70 dB, 10 kHz full scale sine wave

Output resistance

50 Ω ±1%

Connector type

BNC(f)

Overvoltage protection

±20 V