Dimensions are shown in mm (inch)

Dimensions subject to change

www.ittcannon.com

E-14

ESM and DSM Single and Double Switch Modules

Technical data

Material of caps

Silicone rubber

Density

IP 60 (dust tight) to IP 65 (dust tight and

protected against water jets)

acc. to IEC 529 due to design

Sealed against

Dust, water, drinks (Cola), oils, solvents, etc.

Cable

further connections upon request

Graphics

Arrows: see drawing; other upon request

Switches

K12A, K12G or PVA1H4

further details of these switches:

see the K12 section in this catalog

The single switch module ESM and the

double switch module DSM are ready-

to-be-installed units, consisting of:

Switch: K12, K12G or PVA1H4;

the K12G switch has two snap-points

and can only be used in DSM.

PVA1H4 only to be used in ESM.

PC board

Rubber cap

Optional cable or connector

The rubber cap offers the possibility to

use the switch modules, ESM and DSM,

under severe ambient conditions where

dust, water, oil, solvents can effect or

destroy the function of switches. With

the rubber cap, the two modules are

sealed: IP 60 (dust tight) to IP 65 (dust

tight and protected against water jets)

according to DIN/IEC 529. This is the

reason these single or double modules

are used in panels and control grips.

ITT Cannon Switch Products offers the

single and double switch modules as

well as complete panels and Multi-Func-

tion Grips equipped with these switch

modules.

Applications

Tractors

Harvesting equipment

Industrial controls

Standard features are:

Travel

Operating force

K12

1 mm (0.039 inch)

5N (500 grams)

K12G with two snap point:

1.5 mm (0.0591 inch)

3.5N and 7N

only for DSM

(350 grams and 700 grams)

PVA1H4: only for ESM

2.2 mm (0.087 inch)

3N (300 grams)

Ordering code: see next page