ST25DV04K datasheet(40/197 Pages) STMICROELECTRONICS

номер детали	ST25DV04K

подробное описание детали	Dynamic NFC/RFID tag IC with 4-, 16-, or 64-Kbit EEPROM, and fast transfer mode capability

PDF	197 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

40 / 197 page

At boot EH_EN (in EH_CTRL_Dyn register) is set depending EH_MODE value as shown in table below:

Table 38. Energy harvesting at power-up

EH_MODE

EH_EN (at boot)

Energy harvesting at power-up

EH enabled after boot (when possible)

EH disabled initially,

EH delivered on demand (when possible)

Writing 0 in EH_MODE at any time after boot will automatically set EH_EN bit to 1, and thus activate energy

harvesting.

Writing 1 in EH_MODE at any time after boot will not modify EH_EN bit (until next reboot) and thus will not modify

energy harvesting current state.

EH_CTRL_Dyn allows to activate or deactivate on the fly the Energy harvesting (EH_EN) and bring information

on actual state of EH and state of power supplies :

•

EH_ON set reflects the EH_EN bit value

•

FIELD_ON is set in presence of a RF field

•

VCC_ON is set when Host power supply is on, and low power-down mode is not forced.

During boot, EH is not delivered to avoid alteration in device configuration.

Caution:

Communication is not guaranteed during EH delivery. Refer to the application note AN4913 (Energy harvesting

delivery impact on ST25DVxxx behaviour during RF communication).

Energy harvesting can be set even if ST25DVxxx is in RF disabled or RF Sleep mode, or in Low power mode.

In all these cases, ST25DVxxx will deliver power on V_EH pin if RF field is present. Energy harvesting voltage

output is not regulated.

ST25DV04K ST25DV16K ST25DV64K

Energy harvesting (EH)

DS10925 - Rev 11

page 40/197

ST25DV04K датащи(PDF) 40 Page - STMicroelectronics