P13

www.vishay.com

Vishay Sfernice

Upgrade for Submarine Version to P13SM

Revision: 21-Nov-2022

4

Document Number: 51034

For technical questions, contact: sferpottrimmers@vishay.com

THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT

ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000

OPTIONS

Special feature command shaft

Length is measured from the mounting surface to the free end of the shaft. The screwdriver slot is

aligned with the wiper within ± 10°. Special shafts are available, in accordance to drawings supplied

by customers. We recommend that customers should not machine tool shafts, in order to avoid

damage. Bending or torsion of terminals should also be avoided.

Panel sealing

Potentiometers P13T and P13L can be fitted with a device providing sealing between the threaded

bushing and the front panel. Their designation is P13P and P13N respectively or with a locating peg

P13P...E and P13N...E.

Panel sealed version

P13P

P13P...E: Including locating peg

Panel sealed version

P13N

P13N...E: Including locating peg

Shaft locking

On potentiometers equipped with a 3 mm Ø shaft, shaft locking can be obtained:

• Either by a taper nut tightening a slotted bushing. Ask for P13O type. These devices are normally

equipped with an AB type shaft (12.5 mm with a slot).

P13O

• Or by a tightening nut locked by a screw. Ask for ES1 type. On potentiometers equipped with a

Ø 6 mm shaft, locking can be obtained by a taper nut applying pressure on a slotted notched washer.

This device is supplied in a box as an accessory. Ask for DBAN.

These devices are ordered separately. Please consult Vishay Sfernice.

P13L DBAN

No locking on shaft Ø 4 mm.

2.4

1.6

5.08

1.6

0.3

2

0.8

5.08

AJ = 22

AB = 12.5

AA = 9.5

Ø 3

Ø 12.6

13.2 max.

8

Thread M6 x 0.75

Slot 0.6 x 1 deep

5

0.7

Ø 1.5

3.9 ± 0.2

Ø 6.5

Panel Cutout

2.4

1.6

5.08

1.6

0.3

2

0.8

5.08

FQ = 47.5

FE = 13.5

Ø 6

Ø 14

13.5 max. 9.5

Thread M10 x 0.75

Slot 1 x 1.8 deep

5

FK = 22.5

Panel Cutout

Ø 1.5

6.9 ± 0.2

Ø 10.5

Ø 16

0.7

10 wrench

Slotted bushing

Thread M6 x 0.75

8 wrench

11

Ø 3

AB = 12.5

12 wrench

6.5