After pressing each button one time, you can see the binary code for each button (it’s

highlighted in red):

Save your binary codes for each button press (you can also use the Decimal or Tri-

State codes):



Button 3 ON = (24Bit) Binary: 000101010101000101010101



Button 3 OFF = (24Bit) Binary: 000101010101000101010100



Button 4 ON = (24Bit) Binary: 000101010101010001010101



Button 4 OFF = (24Bit) Binary: 000101010101010001010100

Save your Pulse Length: 416 Microseconds and Protocol: 1.

Send the RF Signals (codes)

You’ll need to customize the next sketch with your binary codes, pulse length and

protocol:

/*

Based on the SendDemo example from the RC Switch library

https://github.com/sui77/rc-switch/

*/

#include

RCSwitch mySwitch = RCSwitch();

void setup() {

Serial.begin(9600);

// Transmitter is connected to Arduino Pin #10

mySwitch.enableTransmit(10);

// Optional set pulse length.

mySwitch.setPulseLength(REPLACE_WITH_YOUR_PULSE_LENGTH);