2.3.1

Power up slew

To ensure proper operation of the module, the following minimum slew rates on the supplies must be met for

correct operation of the power on reset (POR) circuitry. The POR circuitry triggers at 0.9 V, but the supplies

should reach their operation levels in accordance with the slew rates listed in the table below.

Note:

The minimum reset time is the minimum time required for the device ROM to load and boot up after IOVDD

reaches the POR rising threshold. The supply must have reached the minimum operating level (1.6 V) within this

time.

Note:

The minimum slew rate on the IOVDD is the same regardless of 1.8 V or 2.8 V operation.

Note:

The AVDD rise time is determined by the internal analogue levels which must be stable for correct operation.

Supply status

AVDD slew

IOVDD slew

Start together

0.001 V/µs

0.012 V/µs

AVDD stable followed by IOVDD

—

0.012 V/µs

IOVDD stable followed by AVDD

0.001 V/µs

—

2.3.2

VL53L7CX

Power up sequence

DS13865 - Rev 3

page 10/40