We manufacture diode lasers.

Member of

Group

Lumics GmbH Berlin. This specification is subject to change without notice.

Fiber Connector

(1) Lumics laser diode fiber coupling technology ensures loss into the fiber cladding of <2% of the total power if the fiber centricity is below 10µm and ferrule

diameter and distance of the fiber end facet to the reference plane complies with shown technical drawing. Use a fiber microscope to check for dust free

fiber end facet and fiber centricity.

(2) Free standing fibers suffer from higher risk of fiber damage to the fiber tip due to mechanical stress by handling and the fiber end facet can not be

polished as simple as for not free standing fibers.

(3) For more information see http://www.lumics.de/wp-content/uploads/lu_fiber_patchcords.pdf

User Safety

70W

520 - 2000nm

VISIBLE AND INVISIBLE LASER RADIATION

AVOID EYE OR SKIN EXPOSURE

TO DIRECT OR SCATTERED RADIATION

CLASS 4 LASER PRODUCT

IEC 60825-1 2007-3

AVOID EYE OR SKIN EXPOSURE TO

DIRECT OR SCATTERED RADIATION

OUTPUT POWER

WAVELENGTH

CLASS IV LASER PRODUCT

VISIBLE AND INVISIBLE LASER RADIATION

DANGER

70W

520 - 2000nm

Important Note Read and carefully follow operating manual instructions. Especially,

whenever power supply is switched on or off, always disconnect from laser module.

See manual for details. Uncontrolled on / off switching may cause spikes and result

in fatal device damage. This product is not certified by with IEC 60825-1 or 21CFR1040.10/

21CFR1040.11 and and must comply with the applicable regulations by the Purchaser

if sold as laser product.

General Parameters / Accessories

Parameter

Symbol

Min

Typ

Max

Unit

Storage Temperature

TS

-10

55

°C

Internal operating * and (Ambient) temp , c.w.-operation **

Top c.w.

10(5)

35(40)

°C

Humidity / Non-condensing Atmosphere

90

%

Thermal heat sink resistance

0.1

k/W

Maximum fiber flange temperature

50

°C

Weight

160

g

Compliance

CE, ROHS

Further Options (Please ask for quotation if needed)

Optical fiber patchcord, Laser diode drivers for each individual wavelength, Interface cable , OEM laser diode driver and temperature controller

* taken at internal temperature sensor ** we recommend to operate the laser above dew point. Below dew point water condensation on the exit window may damage the window

when laser is switched on. If the module was stored below dew point before operation dry the window by pre-heating the module to 25°C

Complies with 21 CFR1040.10