12

H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Presses\AP-K2N\TS010-00 AP-K2N Operation

Manual.doc

4. CONTROL BOX CONFIGURATION

1. Counter

Counts the number of crimped terminations. Reset the

counter to 0 to begin counting operations.

2. Reset Push-button

Press this button to reset the counter (resets the counter

to 0)

3. Function Indicator Lamps

• Rear Cover

The rear cover indicator lamp is lit when the belt-cover

is open. Whilst this lamp is lit, the motor does not

operate even if the Power On push-button is pushed.

CAUTION

DO NOT OPEN THE BELT COVER WHILST MOTOR IS

RUNNING, BECAUSE THE FLYWHEEL CONTINUES

TO ROTATE FOR A FEW SECONDS AFTER THE

MOTOR IS TURNED OFF DUE TO INERTIA STORED

IN THE FLYWHEEL.

• Auto Power-Off

When the crimping operation stops for a period of

approximately 3 minutes or more, for example when

you unintentionally leave the motor running after

finishing work or temporarily stop the operation,

the motor automatically stops and the Auto Power-

off indicator lamp illuminates.

If the Rear Cover indicator illuminates, close the cover

and press the Power On push-button to restart. If the

Auto Power Off indicator illuminates, just press the

Power On push-button to restart.

4. Power On Push-button (green Indicator

Lamp)

Press this button to turn on the motor. The green

indicator lamp illuminates and stays lit whilst the motor is

running.

5. Power Off Push-button (Red Indicator

Lamp)

Press this button to turn off the motor. The red Power Off

indicator lamp illuminates.

6. Circuit Protector Push-button (Thermal

Overload device)

When the crimping machine is overloaded, the Circuit

Protector push-button ‘pops out’, and the motor stops.

Wait for at least one minute, press the Circuit Protector

Push-button in, then press the Power On push-button.

Contact the JST Service Department if you think that the

Circuit Protector is activated too often because the press

may require attention.

7. Operation Light Switch (Ope. Light)

This switch controls the Worklamp. Press it to the right to

turn the light on, and to the left to turn it off.

The lamp-bulb is rated at 40 Watts and is of the ‘Rough

Service’ type. Do not exceed 40 Watts because the

surface temperature of the worklamp exceeds the

maximum recommended temperature.

1. COUNTER

2. RESET

3. FUNCTION

INDICATOR LAMPS

4. POWER ON

PUSH-BUTTON (GREEN)

5. POWER OFF

PUSH-BUTTON (RED)

6. CIRCUIT PROTECTOR

PUSH-BUTTON

7. OPERATION LAMP

SWITCH