3

TL-N/TL-Q

DC 3-Wire Models

* The response frequency is an average value. Measurement conditions are as follows: standard sensing object, a distance of twice the standard sensing object, and

a set distance of half the sensing distance.

Item

Model

TL-Q2MC1

TL-Q5MC

@/TL-Q5MB1

Sensing

distance

2 mm

±15%

5 mm

±10%

Set distance

0 to 1.5 mm

0 to 4 mm

Differential travel

10% max. of sensing distance

Detectable object

Ferrous metal (The sensing distance decreases with non-ferrous metal. Refer to Engineering Data on page 6.)

Standard

sensing object

Iron, 8

× 8 × 1 mm

Iron, 15

× 15 × 1 mm

Response time

---

2 ms max.

Response

500 Hz

Power supply volt-

age (operating volt-

age range)

12 to 24 VDC (10 to 30 VDC), ripple (p-p): 10% max.

Current

consumption

15 mA max. at 24 VDC (no-load)

10 mA max. at 24 VDC

Control

output

Load

current

NPN open collector

100 mA max. at 30 VDC max.

TL-Q5MC

@: NPN open collector,

50 mA max. at 30 VDC max.

TL-Q5MB

@: PNP open collector,

50 mA max. at 30 VDC max.

Residual

voltage

1 V max. (under load current of 100 mA with cable length of

2 m)

1 V max. (under load current of 50 mA with cable length of

2 m)

Indicators

Detection indicator (red)

Operation mode

(with sensing object

approaching)

NO

B1/C1 Models: NO

C2 Models: NC

Refer to the timing charts under DC 3-Wire Models on page 7 for details.

Protection

circuits

Reverse polarity protection, Surge suppressor

Ambient

temperature range

Operating/Storage:

−10 to 60°C (with no icing or condensa-

tion)

Operating/Storage:

−25 to 70°C (with no icing or condensa-

tion)

Ambient

humidity range

Operating/Storage: 35% to 95% (with no condensation)

Temperature

influence

±10% max. of sensing distance at 23°C in the temperature

range of

−10 to 60°C

±20% max. of sensing distance at 23°C in the temperature

range of

−25 to 70°C

Voltage

influence

±2.5% max. of sensing distance at rated voltage in rated voltage ±10% range

Insulation

resistance

50 M

Ω min. (at 500 VDC) between current-carrying parts

and case

5 M

Ω min. (at 500 VDC) between current-carrying parts and

case

Dielectric strength

1,000 VAC for 1 min between current-carrying parts and

case

500 VAC, 50/60 Hz for 1 min between current-carrying parts

and case

Vibration

resistance

Destruction: 10 to 55 Hz, 1.5-mm double amplitude for 2 hours each in X, Y, and Z directions

Shock resistance

tions

tions

Degree of

protection

IEC 60529 IP67,

in-house standards: oil-resistant

IEC IP67

Connection

method

Pre-wired Models (Standard cable length: 2 m)

Weight

(packed state)

Approx. 60 g

Approx. 90 g

Materi-

als

Case

Heat-resistant ABS

Sensing

surface

Accessories

Instruction manual

---