User Manual

13 of 41

Revision 1.4

2019-10-11

EVAL-M3-CM615PN User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M3-CM615PN

4.2

iMOTION™ development tools and software

The iMOTION™Development Tool installers for MCEDesigner and MCEWizard are available for download via

variants are listed there.

On-board debugger uses the SEGGER J-Link’s driver for UART communication with IMC102T-F064. J-Link driver

will be installed during the MCEDesigner installation. In case the driver is not installed properly, please go to

Windows”.

4.2.1

MCEWizard setup overview

After installing the MCEWizard, the shortcut for MCEWizard appears on the Windows desktop. Double click the

shortcut to open the MCEWizard and configure the parameters for evaluation boards or motor. Figure 6 shows

the “Welcome Page” for MCEWizard, where the MADK control board or power board can be selected through

the pull-down list. Infineon keeps releasing new MADK controller and power boards. Therefore, it could happen

that some of the newest power boards are not pre-configured in the MCEWizard tool and cannot be selected

through the pull-down menu. In that case, the user should select any other power board (as similar as possible)

and follow the MCEWizard setup steps by entering the parameter values which are specific to the chosen board.

Make sure both “I have modified the circuit board” and “Enable advanced question” checkmarks are selected.

Please refer to the User Manual of the corresponding power board for additional information.

After selecting the MADK control and the power board, start the MCEWizard system setup procedure by clicking

the “Next” button in the right bottom corner as shown in Figure 6.

Figure 5

Welcome Page of MCEWizard

iMOTION™ MADK system enables users to easily test different combination of control and power board with

their motors. User should be familiar with the system level parameters which are related to the motor used.

There are very limited numbers of parameters which are specific to the control board or power board

hardware. Table 7 provides the MCEWizard setup overview for hardware related parameters. Similar tables will

be available in each control board’s User Manual. Combination of this table and the corresponding table of the

control board provides enough information to setup the MADK-based motor drive system in shortest time.