12MHZSLASHSSLASH3.2X2.5 datasheet(15/41 Pages) INFINEON

15 / 41 page

User Manual

15 of 41

Revision 1.6

2019-07-16

EVAL-M3-102T User Manual

iMOTION™ Modular Application Design Kit

Getting Started with EVAL-M3-102T

drive parameter set into your project directory by clicking “Export to Designer file (.txt)”. Saved Drive

System Parameter File will be later used by the MCEDesigner. Refer to Chapter 4.2.1 or MCEWizard User

Guide for more details.

5. Connect motor phase outputs to the motor.

6. Connect AC power to power input connector and power on system.

7. Start MCEDesigner tool and open MCEDesigner default configuration file (.irc) for IMC102T-F064 controller

(IMC102T_Vxxx.irc) by clicking “File” > “Open”. IMC102T_Vxxx.irc file is included in ”IMC102T-F064 MCE

Software Package” downloaded in step 1.

8. MCEDesigner should automatically connect to the EVAL-M3-102T control board using default COM port

(Indicated by green circle next to “COMx Up” status in the bottom frame of the MCEDesigner GUI). If it

cannot establish the connection, change COM port by doing following steps: (“System” window active) >

Preferences > Connection > Connect using (Chose one of the other available COM ports from the drop-down

menu).

9. In case the IMC102T-F064 IC on the EVAL-M3-102T is empty (not programmed), which will be indicated by

the pop-up window message after connecting to the MCEDesigner, then use following steps to program the

firmware and the system parameters into the internal SRAM of iMOTION™ IC: Click “Tools” > “Programmer”

and select “Program Firmware and Parameters”. Browse and select the IMC102T-F064_A_Vxxx.ldf file which

was included in the IMC102T-F064 MCE Software Package” downloaded in step 1. Then browse and select

the System Drive Parameters .txt file created in step 4. See chapter MCEDesigner setup overview 4.2.2 for

more details.

10. Use following steps to program the system parameters into the internal SRAM of iMOTION™ IC: Click

“Tools” > “Programmer” and select “Program Parameters”. Browse and select the System Drive

Parameters .txt file created in step 4. See chapter MCEDesigner setup overview 4.2.2 for more details.

11. Start the motor by clicking the green traffic light button in the control bar.

Figure5 SystemconnectionexampleusingEVAL-M3-102TandEVAL-M3-CM615PN

PC-USB

Connector

Motor Phase

Outputs

AC Power

Input

PFC

Inductor

12MHZ/S/3.2X2.5 датащи(PDF) 15 Page - Infineon Technologies AG