Open Base & AV2 Right Angle Terminal Style

BD08AV2

PC MOUNTING

SPST

NOTE: Boxed dimensions show difference between AV & AV2 terminal styles.

Standard Profile DIP Switches

BD Series

D

D-14

C&K Components, Inc. Web Site: www.ckcorp.com Americas Sales Tel: 800-635-5936 Fax: 617-926-6846

Europe Sales Tel: +44-1536-521147 Fax: +44-1536-411602

S Asia Sales Tel: +852-2798-6393 Fax: +852-2751-9926

PART NUMBER

NO. POS.

DIM. ‘A’

QUANTITY

PER TUBE

BD02AV2

2

.280 (7,11)

72

BD03AV2

3

.380 (9,65)

52

BD04AV2

4

.480 (12,19)

42

BD05AV2

5

.580 (14,73)

35

BD06AV2

6

.680 (17,27)

29

BD07AV2

7

.780 (19,81)

26

BD08AV2

8

.880 (22,35)

23

BD09AV2

9

.980 (24,89)

20

BD10AV2

10

1.080 (27,43)

18

BD12AV2

12

1.280 (32,51)

15

Schematic

SPST

Installation, Soldering and Cleaning

All BD Series Standard Profile DIP Switches can be hand soldered or machine soldered without the use of boots, caps, tapes or

special attention. Open base washable models have unique design, allowing solvent cleaners and water/detergent solutions to flush

and clean the electrical contacts of contaminants and fluxes. Closed base models with epoxy terminal sealing recommended for

no-wash or bottom-wash assembly methods only. For best results, follow these recommendations:

1) Wave soldering recommended at 500

_ F solder temperature.

2) Hand solder using 30 watt small tip iron controlled at 500

_ F, 10 seconds max./terminal.

3) Open base washable models: Clean flux using forced rinse, high agitation or triple bath cleaning method.

DO NOT mask or cover switch in any way during cleaning. Switch is designed for easy solvent flush out.

4) Closed base models with epoxy terminal seal: Recommended for no-wash or bottom-wash assembly methods only.

5) All switch actuators must be in ‘OFF’ position during soldering and cleaning processes.

Rev. A 8/99