SMS47 datasheet(14/19 Pages) SUMMIT

14 / 19 page

SMS47

2087 1.1 04/11/05

SUMMIT MICROELECTRONICS, Inc.

Preliminary Information

Figure 10. START and STOP Conditions

2047 Table11 1.0

Table 11. Slave Addresses

START and STOP Conditions

When both the data and clock lines are high the bus is said

to be not busy. A high-to-low transition on the data line,

while the clock is high, is defined as the Start condition.

A low-to-high transition on the data line, while the clock

is high, is defined as the Stop condition. See Figure 10.

Acknowledge (ACK)

Acknowledge is a software convention used to indicate

successful data transfers.

The transmitting device,

either the Master or the Slave, will release the bus after

transmitting eight bits. During the ninth clock cycle the

receiver will pull the SDA line low to Acknowledge that it

received the eight bits of data. The Master will leave the

SDA line high (NACK) when it terminates a read function.

The SMS47 will respond with an Acknowledge after recog-

nition of a Start condition and its slave address byte. If both

the device and a write operation are selected the SMS47

will respond with an Acknowledge after the receipt of each

subsequent 8-Bit word. In the READ mode the SMS47

transmits eight bits of data, then releases the SDA line, and

monitors the line for an Acknowledge signal. If an Acknowl-

edge is detected and no Stop condition is generated by the

Master, the SMS47 will continue to transmit data. If a

NACK is detected the SMS47 will terminate further data

transmissions and await a Stop condition before returning

to the standby power mode.

Device Addressing

Following a Start condition the Master must output the

address of the Slave it is accessing. The most significant

four bits of the Slave address are the device type

identifier/address. For the SMS47 the default is 1001BIN.

The next two bits are the Bus Address. The next bit (the

7th) is the MSB of the configuration register address.

Read/Write Bit

The last bit of the data stream defines the operation to be

performed. When set to 1 a Read operation is selected;

when set to 0 a Write operation is selected.

WRITE OPERATIONS

The SMS47 uses byte Write operations. A byte Write

operation writes a single byte during the nonvolatile write

period (tWR).

Byte Write

After the Slave address is sent (to identify the Slave device

and select either a Read or Write operation), a second byte

is transmitted which contains the low order 8 bit address

of any one of the 256 words in the array. Upon receipt of

the word address the SMS47 responds with an Acknowl-

edge. After receiving the next byte of data it again

responds with an Acknowledge. The Master then termi-

nates the transfer by generating a Stop condition, at which

time the SMS47 begins the internal Write cycle. While the

internal Write cycle is in progress the SMS47 inputs are

disabled and the device will not respond to any requests

from the Master.

Acknowledge Polling

When the SMS47 is performing an internal Write operation

it will ignore any new Start conditions. Since the device will

only return an acknowledge after it accepts the Start the

part can be continuously queried until an acknowledge is

issued, indicating that the internal Write cycle is complete.

See the flow chart for the proper sequence of operations for

polling.

2047 Fig10

SCL

SDA In

START

Condition

STOP

Condition

I2C PROGRAMMING INFORMATION (CONTINUED)

SMS47 датащи(PDF) 14 Page - Summit Microelectronics, Inc.

SMS47 датащи(HTML) 14 Page - Summit Microelectronics, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

датащи скачать

ссылки URL