Specifications

VV5430

CD5430F-A

4/33

2.

Specifications

2.1

Device Specifications

Figure 1 : Spectral Response

The sensor is tested using the example support circuit illustrated later in this document. Standard imaging conditions used for

optical tests employ a tungsten halogen lamp to uniformly illuminate the sensor (to better than 0.5%), or to illuminate specific

areas. A neutral density filter is used to control the level of illumination where required.

Table 2 : Absolute Maximum Ratings

Note: Stresses exceeding the Absolute Maximum Ratings may induce failure. Exposure to absolute maximum ratings

for extended periods may reduce reliability. Functionality at or above these conditions is not implied.

Table 3 : DC Operating Conditions

Parameter

Value

Supply Voltage

-0.5 to +7.0 volts

Voltage on other input pins

Ambient Operating Temperature

(contact STMicroelectronics for extended temp. ranges)

Storage Temperature

Maximum DC TTL output Current Magnitude

10mA (per o/p, one at a time, 1sec. duration)

Symbol

Parameter

Min.

Typ.

Max.

Units

Notes

Operating supply voltage

4.75

5.0

5.25

Volts

Input Voltage Logic “1”

2.4

Volts

Input Voltage Logic “0”

-0.5

0.8

Volts

Ambient Operating Temperature

0

40

Still air

Illumination Colour Temp.

Clock Frequency

Std. CCIR

Exposure

Maximum

Gain

x1

Auto. Gain Control (AGC)

Off

Correction mode

Linear

1.0

0.8

0.6

0.4

0.2

0

Wavelength nm