MAX17543_V01 datasheet(16/19 Pages) MAXIM

16 / 19 page

The junction temperature of the device can be estimated

at any given maximum ambient temperature (TA_MAX)

from the equation below:

(

)

+ θ

J_MAX

A_MAX

LOSS

If the application has a thermal management system that

ensures that the exposed pad of the device is maintained

at a given temperature (TEP_MAX) by using proper

heatsinks, then the junction temperature of the device can

be estimated at any given maximum ambient temperature

from the equation below:

(

)

+ θ

J_MAX

EP_MAX

LOSS

Junction temperature greater than +125°C degrades

operating lifetimes.

PCB Layout Guidelines

All connections carrying pulsed currents must be very

short and as wide as possible. The inductance of these

connections must be kept to an absolute minimum due to

the high di/dt of the currents. Since inductance of a current

carrying loop is proportional to the area enclosed by the

loop, if the loop area is made very small, inductance is

reduced. Additionally, small-current loop areas reduce

radiated EMI.

A ceramic input filter capacitor should be placed close

to the VIN pins of the IC. This eliminates as much trace

inductance effects as possible and gives the IC a cleaner

voltage supply. A bypass capacitor for the VCC pin also

should be placed close to the pin to reduce effects of trace

impedance.

When routing the circuitry around the IC, the analog

small-signal ground and the power ground for switching

currents must be kept separate. They should be connected

together at a point where switching activity is at a

minimum, typically the return terminal of the VCC bypass

capacitor. This helps keep the analog ground quiet.

The ground plane should be kept continuous/unbroken

as far as possible. No trace carrying high switching

current should be placed directly over any ground plane

discontinuity.

PCB layout also affects the thermal performance of the

design. A number of thermal vias that connect to a large

ground plane should be provided under the exposed pad

of the part, for efficient heat dissipation.

For a sample layout that ensures first pass success,

refer to the MAX17543 evaluation kit layout available at

www.maximintegrated.com.

MAX17543

4.5V–42V, 2.5A, High-Efficiency,

Synchronous Step-Down DC-DC Converter

with Internal Compensation

www.maximintegrated.com

Maxim Integrated │ 16

MAX17543 датащи(PDF) 16 Page - Maxim Integrated Products

MAX17543 датащи(HTML) 16 Page - Maxim Integrated Products

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19

датащи скачать

ссылки URL