7.3.1.5 Configuration Pulse

The DLPR410 device is configured in serial mode when it holds configuration pulse pin, CF, high and it enables

the CE and OE pins. New data is available a short time after each rising clock edge.

7.3.1.6 Revision Selection

The device uses the REV_SEL0, REV_SEL1, and EN_EXT_SEL signals to select a revision to act as the

default. Setting all three signals to GND defaults to revision 0 for simple DLPR410 device setup.

7.4 Device Functional Modes

To successfully program the DLPC410ZYR controller upon power-up, the DLPR410 device must be configured

and connected to the DLPC410ZYR controller as shown in Figure 7-2.

www.ti.com

DLPR410

DLPS027G – AUGUST 2012 – REVISED AUGUST 2021

Copyright © 2021 Texas Instruments Incorporated

Submit Document Feedback

9

Product Folder Links: DLPR410