MODEL: R80

R80 SPECIFICATIONS

ES-7021 Rev.0 Page 3/6

http://www.m-system.co.jp/

• I/O Module

A

B

Confirm that the locking clamps of the I/O module are set.

Insert the module in parallel to the next one while aligning the grooves of

both modules (A & B in the above figure).

Maintain it perpendicularly to the rail.

More I/O modules can be added in the same manner.

• Protective Cover

Hook

Groove

When removing the cover, pull it out while squeezing the hooks inward.

The protective cover is to be attached over the connected I/O module

at the right end.

Align the hooks on the cover with the grooves of the module and slide it

straight until the hooks are latched.