MPC5602P datasheet(43/95 Pages) NXP

43 / 95 page

MPC5602P Microcontroller Data Sheet, Rev. 6

Freescale Semiconductor

NOTE

The voltage regulator output cannot be used to drive external circuits. Output pins are to be

used only for decoupling capacitance.

VDD_LV_COR must be generated using internal regulator and external NPN transistor. It is

not possible to provide VDD_LV_COR through external regulator.

For the MPC5602P microcontroller, capacitor(s), with total values not below CDEC1, should be placed between

VDD_LV_CORx/VSS_LV_CORx close to external ballast transistor emitter. 4 capacitors, with total values not below CDEC2, should

be placed close to microcontroller pins between each VDD_LV_CORx/VSS_LV_CORx supply pairs and the

VDD_LV_REGCOR/VSS_LV_REGCOR pair . Additionally, capacitor(s) with total values not below CDEC3, should be placed

between the VDD_HV_REG/VSS_HV_REG pins close to ballast collector. Capacitors values have to take into account capacitor

accuracy, aging and variation versus temperature.

All reported information are valid for voltage and temperature ranges described in recommended operating condition, Table 8

and Table 9.

Figure 8. Voltage regulator configuration

Table 13. Approved NPN ballast components

Part

Manufacturer

Approved derivatives1

BCP68

ON Semi

BCP68

NXP

BCP68-25

Infineon

BCP68-25

BCX68

Infineon

BCX68-10; BCX68-16; BCX-25

BC868

NXP

BC868

BCTRL

VDD_LV_COR

CDEC3

CDEC2

CDEC1

VDD_HV_REG

BJT(1)

MPC5602P

1 Refer to Table 13.

MPC5602P датащи(PDF) 43 Page - NXP Semiconductors

MPC5602P датащи(HTML) 43 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95

датащи скачать

ссылки URL