MODEL: R3-PS1

R3-PS1 SPECIFICATIONS

ES-8359 Rev.13 Page 1/3

https://www.m-system.co.jp/

Remote I/O R3 Series

POWER SUPPLY MODULE

(single slot, continuous output current 750 mA)

109

[4.29]

27.5 [1.08]

130

[5.12]

mm [inch]

MODEL: R3-PS1-[1][2]

ORDERING INFORMATION

• Code number: R3-PS1-[1][2]

Specify a code from below for each of [1] and [2].

(e.g. R3-PS1-R/CE/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] POWER INPUT

AC Power

K: 85 – 132 V AC

(Operational voltage range 85 – 132 V, 47 – 66 Hz)

(CE not available)

L: 170 – 264 V AC

(Operational voltage range 170 – 264 V, 47 – 66 Hz)

(CE Not available)

DC Power

R: 24 V DC

(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)

P: 110 V DC

(Operational voltage range 85 – 150 V, ripple 10 %p-p max.)

(CE not available)

[2] OPTIONS (multiple selections)

Standards & Approvals

blank: Without CE

/CE: CE marking

Other Options

blank: none

/Q: Option other than the above (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

GENERAL SPECIFICATIONS

Connection

Internal power output: Via the Installation Base (model: R3-

BSx)

Power input, RUN contact output: M3 separable screw

terminal (torque 0.5 N·m)

Screw terminal: Nickel-plated steel

Isolation: Internal power to power input to RUN contact

output to FG

Power indicator LED: Green LED turns on when the power is

supplied.

■ RUN CONTACT OUTPUT

RUN contact: Turns on (closed) while the power is supplied.

(Available with Ver.1.01 or higher versions)

Rated load: 250 V AC @ 0.5 A (cos ø = 1)

30 V DC @ 0.5 A (resistive load)

(Less than 50 V AC to conform with EU Directive)

Maximum switching voltage: 250 V AC or 30 V DC

Maximum switching power: 250 VA or 150 W

Minimum load: 1 V DC @ 1 mA

When driving an inductive load, external contact protection

and noise quenching recommended.

INSTALLATION

Power consumption (Output current: 750 mA @ 20 V DC)

•AC: Approx. 45 VA

•DC: Approx. 29 W or 1.2 A at 24 V

Output current: 750 mA continuous at 20 V DC; 1000 mA for

10 minutes

(Total current continuously consumed at the network

modules and I/O modules must be within 750 mA.)

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R3-BSx)

Weight: 250 g (0.55 lb)

PERFORMANCE

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @ 1 minute

(internal power to power input to RUN contact output to FG)