MODEL: R30GECT1

R30GECT1 SPECIFICATIONS

ES-9029 Rev.3 Page 1/4

https://www.m-system.co.jp/

Remote I/O R30 Series

EtherCAT INTERFACE I/O MODULE

(EtherCAT)

Functions & Features

• Serves as a gateway for allowing EtherCAT data to be

handled by network modules that use different protocols.

• Recognized as an analog I/O mixed module by the

network modules.

• Works as a slave station on EtherCAT in the same manner

as R30NECT1.

Typical Applications

• A gateway between EtherCAT and CC-Link IE Filed.

EtherCAT® is a registered trademark and patented

technology, licensed by Beckhoff Automation GmbH,

Germany.

mm [inch]

98

[3.86]

110

[4.33]

25 [.98]

MODEL: R30GECT1S[1]

ORDERING INFORMATION

• Code number: R30GECT1S[1]

Specify a code from below for [1].

(e.g. R30GECT1S/Q)

• Specify the specification for option code /Q

(e.g. /C01)

COMMUNICATION MODE

S: Single

[1] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

CAUTION

Please use this unit with a network module (model:

R30NECT1) of firmware version V1.04.10 or higher, and a

network module (model: R30NCIE1) of firmware version

V1.01.13 or higher.

RELATED PRODUCTS

• PC configurator software (model: R30CFG)

• ESI file

The configurator software and ESI files are downloadable at

M-System’s web site.

Use a commercially available Mini-B USB cable to connect

the unit to a PC.

GENERAL SPECIFICATIONS

Connection

EtherCAT: RJ-45 connector

Internal bus: Via the Installation Base (model: R30BS)

Internal power: Via the Installation Base (model: R30BS)

Isolation: EtherCAT to internal bus or internal power

Internal bus communication cycle: Approx. 1 msec.

Status indicators: PWR, RUN, ERR, L/A IN, L/A OUT

(Refer to the instruction manual.)

EtherCAT COMMUNICATION

Standard: IEEE 802.3u

Transmission type: 100BASE-TX

Transmission speed: Full-duplex 100 Mbps

Transmission media: 100BASE-TX (STP cable; Category 5e)

Maximum internode length: 100 meters

Fixed address: Set with rotary switches

(The master must support MDP.)

INSTALLATION

Current consumption : 80 mA

Operating temperature: -10 to +55°C (14 to 131°F)

Storage temperature: -20 to +65°C (-4 to +149°F)

Operating humidity: 10 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R30BS)

Weight: 110 g (0.24 lb)