MODEL: MSR2K-V6

MSR2K-V6 SPECIFICATIONS

ES-7405 Rev.3 Page 2/14

http://www.m-system.co.jp/

SERVER SOFTWARE (MSR2K-S)

■ HARDWARE REQUIREMENTS

HARDWARE

REQUIREMENTS

PC

IBM PC/AT or compatible

Operating system

Windows 7 Professional (32-bit, 64-bit) or Windows 10 Professional (32-bit, 64-bit)

(The MSR2K may not operate adequately in certain conditions.)

CPU

Pentium IV 2.0 GHz or higher

Screen area

XGA (1024 by 768 pixels) or better resolution

Display color

65000 colors (16 bits)

Main memory

512 MB minimum; 1 GB minimum recommended

Hard disk area

80 GB; Use an internal hard disk. *

1

I/O hardware

R3-NE1, R3-NM1*

R1M-P4*

R7MWTU*

IT50SRE , IT60SRE

CD drive

Windows supported CD drive is used to install the software program.

Communication port

LAN card by Windows

*1. External (e.g. SCSI) devices may impair appropriate performance. Please secure enough hard disk space for the MSR2K data.

Recorded data may be periodically transferred to external storage media to allow new data stored.

*2. 100 msec. storing mode is not selectable.

*3. Real-time connection only.

*4. Single node per station. High speed mode is not selectable.

CAUTION: The software’s performance largely depends upon the PC’s performance including other environmental conditions.

Data sampling may be missed when it is not adequate. The missing parts will be lled with the previously sampled data.

NOTE: When the Server and the Client are used on the same PC, the PC must satisfy the Server’s system requirements.

■Builder Software & MSRpro V1. Conversion Tool: Installed and used in the Server PC.

■SOFTWARE FUNCTIONS

The Server samples data at I/O devices, calculate and store data in files. Stored data is distributed upon request from Clients.

Storing Mode: High speed, Middle speed or Low speed selectable

Data format: Binary, CSV

•Sampling Rate (depends upon number of slave devices)

High speed mode: 100 msec.

Middle speed mode: 1 sec.

Low speed mode: 5 sec.

•Maximum number of I/O signals

High speed mode: 8 groups (256 points)

Middle/low speed mode: 2048 (Limited to 512 when the Server and the Client are in the same PC.)

•Data Storing Method

Normal: Recording is manually initiated and stopped. Data is continuously stored while the recording is on.

Auto: Recording is automatically initiated and stopped at a predefined time (one time only or every day).

Event recording: The Server detects an external event by trigger signal, and stores preset number of samples (max. 120 as

pretrigger, max. 1200 as posttrigger) before and after the moment of event.

Remote trigger: Data is automatically recorded while the external trigger condition (input) is true.

Store conditionally (analog): Data is automatically recorded when a specific analog input signal is within a pre-determined

range.

•Storing Rate (reading and plotting) (selectable per group)

High speed mode: 100, 500 msec.

Middle speed mode: 1, 2, 5, 10, 20, 30 sec., 1 min., 10 min.

Low speed mode: 5, 10, 20, 30 sec., 1 min., 10 min.

•Computation Functions: Square root extraction, arithmetic functions, logic functions, segment linearization and

temperature/pressure compensation, moving average (between 2 - 5 samples), pulse accumulation (between 0.5 - 24 h)

Alarm: Four stages alarm output. Point of contact outputs to the output modules.

•Maximum number of I/O stations

High speed mode: 1 (1 station/1 node only)