MODEL: R5-PA2

R5-PA2 SPECIFICATIONS

ES-6139 Rev.10 Page 1/3

http://www.m-system.co.jp/

Remote I/O R5 Series

TOTALIZED PULSE INPUT MODULE

(Pi 2 points)

96.5

(3.80)

18 (.71)

90

(3.54)

mm (inch)

MODEL: R5–PA2[1][2]

ORDERING INFORMATION

• Code number: R5-PA2[1][2]

Specify a code from below for each [1] and [2].

(e.g. R5-PA2W/Q)

• Specify the specification for option code /Q

(e.g. /C01)

NO. OF CHANNELS

2: 2-point inputs

[1] COMMUNICATION MODE

S: Single

W: Dual

[2] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

GENERAL SPECIFICATIONS

Connection

Internal bus: Via the Installation Base (model: R5-BS)

Input: Euro type connector terminal

stripped length 7 mm)

Internal power: Via the base (model: R5-BS)

Isolation: Pi 1 to Pi 2 to internal bus or internal power

RUN indicator: Bi-color (red/green) LED;

Red when the bus A operates normally;

Green when the bus B operates normally;

Amber when both buses operate normally.

Input status indicator: Red LED; turns on with the inputs ON.

Count reset: Via DIP switches on the side

INPUT SPECIFICATIONS

Input: Dry contact, 2 points

Common: All negatives

Contact detecting: Max. 24 V DC

ON voltage, current: ≥ 15 V, ≥ 2.5 mA

OFF voltage, current: ≤ 6 V, ≤ 1 mA

Maximum frequency: 100 Hz (duty ratio 30 – 70 %)

Totalized pulse range: 1 – 10000 (‘0’ at reset)

Max. pulse range selectable from 100 to 60000 using the

R5CON PC Configurator Software. Refer to the R5CON Users

Manual for detailed information.

Count at overflow: Reset and restart at ‘1.’

INSTALLATION

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R5-BS)

Weight: 100 g (3.53 oz)

PERFORMANCE

Data allocation: 2

Response time: ≤ 0.1 sec.

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 1500 V AC @ 1 minute

(Pi 1 to Pi 2 to internal bus or internal power)

2000 V AC @ 1 minute (power input to FG; isolated on the

power supply module)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

EN 50581