MODEL: R5-NP2

R5-NP2 SPECIFICATIONS

ES-6133 Rev.6 Page 1/4

http://www.m-system.co.jp/

Remote I/O R5 Series

PROFIBUS-DP INTERFACE MODULE

(for 32-point analog signals)

18 (.71)

mm (inch)

90

(3.54)

90

(3.54)

MODEL: R5-NP2[1]

ORDERING INFORMATION

• Code number: R5-NP2[1]

Specify a code from below for [1].

(e.g. R5-NP2/Q)

• Specify the specification for option code /Q

(e.g. /C01)

[1] OPTIONS

blank: none

/Q: With options (specify the specification)

SPECIFICATIONS OF OPTION: Q

COATING (For the detail, refer to M-System's web site.)

/C01: Silicone coating

/C02: Polyurethane coating

/C03: Rubber coating

RELATED PRODUCTS

• PC configurator software (model: R5CON)

• GSD (General Station Description) file

Downloadable at M-System’s web site.

A dedicated cable is required to connect the module to the

PC. Please refer to the internet software download site or

the users manual for the PC configurator for applicable

cable types.

GENERAL SPECIFICATIONS

Connection

PROFIBUS: 9-pin D-sub connector, female

(Lock screw No. 4-40 UNC)

Internal bus: Via the Installation Base (model: R5-BS)

Internal power: Via the base (model: R5-BS)

Isolation: PROFIBUS to internal bus or internal power

RUN indicator: Bi-color (green/red) LED (refer to the

instruction manual)

ERR indicator: Bi-color (green/red) LED (refer to the

instruction manual)

Data allocation: Fixed to Mode 2

PROFIBUS COMMUNICATION

Interface: PROFIBUS-DP, slave (RS-485 isolation)

Max. baud rate: 12 Mbps

Transmission cable: Approved for PROFIBUS-DP

Station address setting: Rotary switch; 00 - 7D

(The station address is programmed to 7D if a larger

number is set on the switches.)

•Special Clear Mode (Fail Safe Mode) is not supported.

However, when the R5-NP2 is initialized

(when the power is turned on), the output of connected

output modules is cleared by value “0”: the discrete outputs

are turned off; the analog outputs are reset to 0 %.

INSTALLATION

Operating temperature: -10 to +55°C (14 to 131°F)

Operating humidity: 30 to 90 %RH (non-condensing)

Atmosphere: No corrosive gas or heavy dust

Mounting: Installation Base (model: R5-BS)

Weight: 100 g (3.53 oz)

PERFORMANCE

Insulation resistance: ≥ 100 MΩ with 500 V DC

Dielectric strength: 2000 V AC @1 minute (PROFIBUS to

internal bus or internal power)

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

RoHS Directive

EN 50581