MCP3561T-ESLASHST datasheet(63/108 Pages) MICROCHIP

63 / 108 page

 2019-2021 Microchip Technology Inc.

DS20006181C-page 63

MCP3561/2/4

6.3

Writing to the Device

When the command type is Incremental Write

(CMD[1:0] = 10), the device enters Write mode and

starts writing the first data byte to the address given in

the CMD[5:2] bits.

After the STATUS byte has been transferred, SDO

stays in a High-Impedance state during an Incremental

Write communication. Writing to a read-only address

(such as addresses 0x0 or 0xF) has no effect and does

not increment the Address Pointer. The user must stop

the communication and restart a communication with a

COMMAND byte pointing to a writable address (0x1 to

0xD).

Each register is effectively written after receiving the

last bit for the register (SCK last rising edge). Any CS

rising edge during a write communication aborts the

current writing. In this case, the register being written

will not be updated and will keep its old value.

The registers may need 8, 16 or 24 bits to be effectively

written, depending on their address (see Table 8-1).

After each register is written, the Address Pointer is

automatically incremented as long as CS stays logic

low. When the Address Pointer reaches 0xD, the next

for a graphical representation of the address looping).

Internal registers located at addresses, 0xB, 0xC and

0xE, should be kept to their default state at all times for

proper operation. These are reserved registers and

should not be modified.

The Incremental Write feature can be used in order to

fully configure the part using a unique communication

which can save time in the application. This unique

communication can end at address 0xD so that the

user can also lock the configuration when written,

providing additional security in the application (see

Sections 6.6 “Locking/Unlocking Register Map

Write Access”).

Figure 6-4 shows an example of a write communication

in detail with a single register write. Figure 6-5 shows an

example of an Incremental Write communication.

FIGURE 6-3:

Incremental Write Loop.

CONFIG1 (0x2)

CONFIG2 (0x3)

CONFIG3 (0x4)

IRQ (0x5)

MUX (0x6)

SCAN (0x7)

TIMER (0x8)

OF FSETCAL (0x9)

GAINCAL (0xA)

Reserved (0xB)

Reserved (0xC)

LOCK (0xD)

Reserved (0xE)

CONFIG0 (0x1)

MCP3561T-E/ST датащи(PDF) 63 Page - Microchip Technology

MCP3561T-E/ST датащи(HTML) 63 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL