RJ21P3AA0PT

4

Color temperature of light source : 3 200 K, IR cut-off filter (CM-500, 1 mmt) is used.)

PARAMETER

SYMBOL

MIN.

TYP.

MAX.

UNIT

NOTE

Standard output voltage

150

mV

2

Photo response non-uniformity

PRNU

10

%

3

Saturation output voltage

450

530

mV

4

Dark output voltage

0.5

3.0

mV

1, 6

Dark signal non-uniformity

DSNU

0.5

2.0

mV

1, 7

Sensitivity (green channel)

R (G)

130

160

mV

8

Smear ratio

SMR

–90

–82

dB

9

Image lag

AI

1.0

%

10

Blooming suppression ratio

ABL

1 000

11

Output transistor drain current

4.0

8.0

mA

NOTES :

1 000 times exposure of the standard exposure conditions,

2.The average output voltage of G signal under uniform

illumination. The standard exposure conditions are

defined as when Vo is 150 mV.

3.The image area is divided into 10 x 10 segments under

the standard exposure conditions. Each segment's

voltage is the average output voltage of all pixels within

the segment. PRNU is defined by (Vmax – Vmin)/Vo,

where Vmax and Vmin are the maximum and minimum

values of each segment's voltage respectively.

4.The image area is divided into 10 x 10 segments.Each

segment's voltage is the average output voltage of all

segment's voltage under 10 times exposure of the

standard exposure conditions. The operation of OFDC is

high. (for still image capturing)

5.The image area is divided into 10 x 10 segments.Each

segment's voltage is the average output voltage of all

segment's voltage under 10 times exposure of the

standard exposure conditions. The operation of OFDC is

low.

6.The average output voltage under non-exposure

conditions.

7.The image area is divided into 10 x 10 segments under

non-exposure conditions. DSNU is defined by (Vdmax –

Vdmin), where Vdmax and Vdmin are the maximum and

minimum values of each segment's voltage respectively.

8.The average output voltage of G signal when a 1 000

lux light source with a 90% reflector is imaged by a lens

of F4, f50 mm.

9.The sensor is exposed only in the central area of V/10

square with a lens at F4, where V is the vertical image

size. SMR is defined by the ratio of the output voltage

detected during the vertical blanking period to the

maximum output voltage in the V/10 square.

10.The

sensor

is

exposed

at

the

exposure

level

corresponding to the standard conditions. AI is defined

by the ratio of the output voltage measured at the 1st

field during the non-exposure period to the standard

output voltage.

11.The sensor is exposed only in the central area of V/10

square, where V is the vertical image size. ABL is

defined by the ratio of the exposure at the standard

conditions to the exposure at a point where blooming is

observed.

5

mV

400

320