MODEL: M2EAXM

M2EAXM SPECIFICATIONS

ES-5153 Rev.1 Page 3/6

http://www.m-system.co.jp/

STANDARDS & APPROVALS

EU conformity:

EMC Directive

EMI EN 61000-6-4

EMS EN 61000-6-2

Low Voltage Directive

EN 61010-1

Measurement Category II (output)

Installation Category II (power)

Pollution Degree 2

Input or output to power: Reinforced insulation (300 V)

Input to output: Basic insulation (300 V)

L1 or L4 alarm output to L2 or L3 alarm output:

Basic insulation (300 V)

RoHS Directive

EN 50581

EXTERNAL VIEW

Up

Down

Mode

Set

PERCENT

50.00

L4 ▲

80.00

L3 ▲

70.00

L2 ▼

30.00

L1 ▼

20.00

%

Display

Mode Button

Set Button

Configurator Jack

Up Button

Down Button

COMPONENT

FUNCTION

Display

Indicates present values, setting values and abnormal information. Two types of present values at upper

and lower are displayed by setting.

Mode button

Used to shift from measuring mode to each setting mode. Destination to shift is changed by the time press-

ing and holding the button. Used to return from each setting mode to measuring mode. (press and hold for

2 sec. or more)

Set button

Used to change setting value of setting parameter. When at setting changeable state, used to enter (save)

the setting value. Used to move on through digits of setting value for input scaling at setting changeable

state.

Used to release latching alarm in measuring mode (hold down more than 2 seconds).

Up button

Used to shift through setting parameter, and to increase or select setting value.

Down button

Used to shift through setting parameter, and to decrease or select setting value.

Con gurator Jack

Used to con gure with M2EA con gurator software (model: M2EACFG). At the same time, set the lockout

setting of the unit to ‘lock’.

Refer to the operating manual (EM-5153-B) for detailed procedures.