8.1.4 Common-Mode Voltage Transients

With a small amount of additional circuitry, the INAx191 can be used in circuits subject to transients that exceed

the absolute maximum voltage ratings. The most simple way to protect the inputs from negative transients is to

add resistors in series to the IN– and IN+ pins. Use resistors that are 1 kΩ or less, and limit the current in the

ESD structures to less than 5 mA. For example, using 1-kΩ resistors in series with the INAx191 allows voltages

as low as –5 V, while limiting the ESD current to less than 5 mA. If protection from high-voltage or more-

negative, common-voltage transients is needed, use the circuits shown in Figure 8-4 and Figure 8-5. When

implementing these circuits, use only Zener diodes or Zener-type transient absorbers (sometimes referred to as

transzorbs); any other type of transient absorber has an unacceptable time delay. Start by adding a pair of

resistors as a working impedance for the Zener diode, as shown in Figure 8-4. Keep these resistors as small as

possible; most often, use around 100 Ω. Larger values can be used with an effect on gain that is discussed in

Section 8.1.3. This circuit limits only short-term transients; therefore, many applications are satisfied with a 100-

Ω resistor along with conventional Zener diodes of the lowest acceptable power rating. This combination uses

the least amount of board space. These diodes can be found in packages as small as SOT-523 or SOD-523.

1.7 V to 5.5 V

IN±

IN+

VS

OUT

+

±

Bus Voltage

up to 40 V

Load

ENABLE

GND

< 1 k:

< 1 k:

0.1 µF

TI Device

Capacitively

Coupled

Amplifier

Figure 8-4. Transient Protection Using Dual Zener Diodes

In the event that low-power Zener diodes do not have sufficient transient absorption capability, a higher-power

transzorb must be used. The most package-efficient solution involves using a single transzorb and back-to-back

diodes between the device inputs, as shown in Figure 8-5. The most space-efficient solutions are dual, series-

connected diodes in a single SOT-523 or SOD-523 package. In either of the examples shown in Figure 8-4 and

Figure 8-5, the total board area required by the INA191 with all protective components is less than that of an

SO-8 package, and only slightly greater than that of an VSSOP-8 package.

1.7 V to 5.5 V

IN±

IN+

VS

OUT

+

±

Bus Voltage

up to 40 V

Load

Capacitively

Coupled

Amplifier

ENABLE

TI Device

GND

< 1 k:

< 1 k:

Transorb

0.1 µF

Figure 8-5. Transient Protection Using a Single Transzorb and Input Clamps

For more information, see Current Shunt Monitor With Transient Robustness Reference Design.

www.ti.com

INA191, INA2191

SLYS020B – FEBRUARY 2019 – REVISED FEBRUARY 2021

Copyright © 2021 Texas Instruments Incorporated

Submit Document Feedback

25

Product Folder Links: INA191 INA2191