TL072CD datasheet(32/69 Pages) TI

32 / 69 page

TL071, TL071A, TL071B

TL072, TL072A, TL072B, TL074, TL074A, TL074B, TL072M, TL074M

SLOS080N – SEPTEMBER 1978 – REVISED JULY 2017

www.ti.com

Product Folder Links: TL071 TL071A TL071B TL072 TL072A TL072B TL074 TL074A TL074B TL072M TL074M

Submit Documentation Feedback

9 Power Supply Recommendations

CAUTION

Supply voltages larger than 36 V for a single-supply or outside the range of ±18 V for a

dual-supply can permanently damage the device (see the Absolute Maximum Ratings).

Place 0.1-μF bypass capacitors close to the power-supply pins to reduce errors coupling in from noisy or high-

impedance power supplies. For more detailed information on bypass capacitor placement, see Layout.

10 Layout

10.1 Layout Guidelines

For best operational performance of the device, use good PCB layout practices, including:

•

Noise can propagate into analog circuitry through the power pins of the circuit as a whole, as well as the

operational amplifier. Bypass capacitors are used to reduce the coupled noise by providing low impedance

power sources local to the analog circuitry.

–

Connect low-ESR, 0.1-μF ceramic bypass capacitors between each supply pin and ground, placed as

close to the device as possible. A single bypass capacitor from V+ to ground is applicable for single-

supply applications.

•

Separate grounding for analog and digital portions of circuitry is one of the simplest and most-effective

methods of noise suppression. One or more layers on multilayer PCBs are usually devoted to ground planes.

A ground plane helps distribute heat and reduces EMI noise pickup. Take care to physically separate digital

and analog grounds, paying attention to the flow of the ground current. For more detailed information, see

Circuit Board Layout Techniques.

•

To reduce parasitic coupling, run the input traces as far away from the supply or output traces as possible. If

it is not possible to keep them separate, it is much better to cross the sensitive trace perpendicular as

opposed to in parallel with the noisy trace.

•

Place the external components as close to the device as possible. Keeping RF and RG close to the inverting

input minimizes parasitic capacitance, as shown in Layout Example.

•

Keep the length of input traces as short as possible. Always remember that the input traces are the most

sensitive part of the circuit.

•

Consider a driven, low-impedance guard ring around the critical traces. A guard ring can significantly reduce

leakage currents from nearby traces that are at different potentials.

TL072CD датащи(PDF) 32 Page - Texas Instruments

TL072CD датащи(HTML) 32 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69

датащи скачать

ссылки URL