EM78P516NH datasheet(49/98 Pages) EMC

49 / 98 page

EM78P516N

8-Bit Microcontroller

Product Specification (V1.0) 04.09.2015

•••• 43

(This specification is subject to change without prior notice)

6.4 I/O Ports

The I/O registers, (Port 5, Port 6, Port 7 and Port 8), are bi-directional tri-state I/O ports.

Port 6 and Port 8 are pulled-high internally by software; Port 6 is also pulled-low internally

by software. Furthermore, Port 6 has its open-drain output also through software. Port 6

and Port 8 features an input status changed interrupt (or wake-up) function and is

pulled-high by software. Each I/O pin can be defined as "input" or "output" pin by the I/O

control register (IOC50 ~ IOC80). The I/O registers and I/O control registers are both

readable and writable. The I/O interface circuits are shown in Figure 6-5.

Note: Open-drain, pull-high, and pull down are not shown in the figure.

Figure 6-5 Circuit of I/O Port and I/O Control Register for Port 5 ~ 8

6.5 Reset and Wake-up

A reset can be activated by

POR (Power-on Reset)

WDT timeout (if enabled)

/RESET pin goes to low

Note: The reset circuit is always enabled. It will reset the CPU at 1.7V.

Once a reset occurs, the following functions are performed

The oscillator is running, or will be started

The program counter (R2/PC) is set to all "0"

All I/O port pins are configured as input mode (high-impedance state)

The TCC/Watchdog timer and prescaler are cleared

When power is on, the Bits 5 and 6 of R3 and the upper two bits of R4 are

cleared.

Bits of the IOC71 register are set to all "1" except for Bit 6 (INT flag)

For other registers, see Table 2

EM78P516NH датащи(PDF) 49 Page - ELAN Microelectronics Corp