| поискавой системы для электроныых деталей |
|
MIC2007 датащи(PDF) 16 Page - Micrel Semiconductor |
|
|
|||||||||||||||||||||||||||||
MIC2007 датащи(HTML) 16 Page - Micrel Semiconductor |
|
16 / 17 page ![]() Micrel MIC2007/MIC2017 October 2005 16 M9999-102805 equation can be used: A A) - (J D J T R P T + × = θ Where: TJ = junction temperature, TA = ambient temperature Rθ(J-A) is the thermal resistance of the package In normal operation, the MIC2007/2017’s Ron is low enough that no significant I 2R heating occurs. Device heating is most often caused by a short circuit — or very heavy load — when a significant portion of the input supply voltage appears across the MIC2007/2017’s power MOSFET. Under these conditions, the heat generated will exceed the package and PCB’s ability to cool the device and thermal limiting will be invoked. In Figure 10, die temperature is plotted against IOUT assuming a constant case temperature of 85°C. The plots also assume a worst case RON of 140 mΩ at a die temperature of 135°C. Under these conditions, it is clear that an SOT-23 packaged device will be on the verge of thermal shutdown (typically 145°C die temperature) when operating at a load current of 1.25A. For this reason, it is recommend that MLF package be used for any MIC2007/2017 designs intending to supply continuous currents of 1A or more. Die Temperature vs. Iout for Tcase = 85°C 0 20 40 60 80 100 120 140 160 0.20 0.40 0.60 0.80 1.00 1.20 1.40 1.60 1.80 2.00 Iout - Amps SOT-23 MLF Figure 10. Die Temperature vs. Package Figure 10 assumes no backside contact is made to the thermal pad provided on the MLF package. For optimal performance at higher current levels, or in higher temperature environments, thermal contact with the PCB and the exposed power paddle on the back side of the MLF package should be made. This significantly reduces the package’s thermal resistance thereby extending the MIC2007/2017’s operating range. It should be noted that this backside paddle is electrically active and is connected to the MIC2007/2017’s GND pin. 2 Vias 0.3 mm diam. to Ground Plane 0.8 mm 1.4 mm Figure 11. Pad for Thermal Mounting to PCB |
|
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |