PI74FCT162Q245AT datasheet(3/6 Pages) PERICOM

3 / 6 page

PI74FCT162Q245T

LOW NOISE 16-BIT BIDIRECTIONAL TRANSCEIVERS

292

PS2050A 04/12/96

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5.0V ± 10%)

Parameters Description

Test Conditions(1)

Min.

Typ(2)

Max.

Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

0.8

IIH

Input HIGH Current

Standard Input, VCC = Max.

VIN = VCC

1µA

IIH

Input HIGH Current

Bus Hold Input(4), VCC = Max.

VIN = VCC

±100

µA

IIL

Input LOW Current

Standard Input, VCC = Min.

VIN = GND

–1

µA

IIL

Input LOW Current

Bus Hold Input(4), VCC = Min.

VIN = GND

±100

µA

IBHH

Bus Hold

Bus Hold Input(4), VCC = Min.

VIN = 2.0V

–50

µA

IBHL

Sustain Current

VIN = 0.8V

+50

IOZH

High Impedance

VCC = Max.

VOUT = VCC

1µA

IOZL

Output Current

VCC = Max.

VOUT = GND

–1

µA

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18 mA

–0.7

–1.2

Output Drive Current

VCC = Max.(3), VOUT = 2.5V

–50

–180

Input Hysteresis

100

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Storage Temperature ................................................................. –65°C to +150°C

Ambient Temperature with Power Applied ................................. –40°C to +85°C

Supply Voltage to Ground Potential (Inputs & Vcc Only) .......... –0.5V to +7.0V

Supply Voltage to Ground Potential (Outputs & D/O Only) ....... –0.5V to +7.0V

DC Input Voltage ......................................................................... –0.5V to +7.0V

DC Output Current ................................................................................... 120 mA

Power Dissipation ......................................................................................... 1.0W

Note:

Stresses greater than those listed under

MAXIMUM RATINGS may cause permanent

damage to the device. This is a stress rating

only and functional operation of the device at

these or any other conditions above those

indicated in the operational sections of this

specification is not implied. Exposure to

absolute maximum rating conditions for

extended periods may affect reliability.

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 5.0V, +25°C ambient and maximum loading.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Pins with Bus Hold are identified in the pin description.

5. This specification does not apply to bi-directional functionalities with Bus Hold.

PI74FCT162Q245AT датащи(PDF) 3 Page - Pericom Semiconductor Corporation

PI74FCT162Q245AT датащи(HTML) 3 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6

датащи скачать

ссылки URL