| поискавой системы для электроныых деталей |
|
IP4787CZ32 датащи(PDF) 21 Page - Nexperia B.V. All rights reserved |
|
|
|||||||||||||||||||||||||||||
IP4787CZ32 датащи(HTML) 21 Page - Nexperia B.V. All rights reserved |
|
21 / 36 page ![]() IP4787CZ32 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2015. All rights reserved. IP4787CZ32 Rev. 3 — 19 December 2014 20 of 35 NXP Semiconductors IP4787CZ32 DVI and HDMI interface ESD and overcurrent protection 9.3 Operating and standby modes The operating mode of IP4787CZ32 depends on the availability of the VCC(5V0) and VCC(SYS) supply voltages and on the state of the ACTIVE input signal. Without availability of both supplies, IP4787CZ32 is in Standby mode. As soon as VCC(5V0) and VCC(SYS) are within the range specified in Section 6, the part is in an operating mode that can be controlled via the ACTIVE input signal. In case ACTIVE is LOW, only the CEC buffer is active and enabled to receive or send CEC commands. All other outputs are in a high-ohmic state. A HIGH input signal enables all parts of IP4787CZ32 and puts the device into full operating mode. [1] X = Don’t care (either LOW or HIGH level); L = LOW-level input; H = HIGH-level input If no CEC Standby mode is required, or if no special Power-down modes are desired, the ACTIVE pin can be pulled HIGH to VCC(5V0) or VCC(SYS) for continuous HDMI and CEC operation as soon as the supplies are aviailable. Strapping the ACTIVE = VCC(SYS) =VDD of ASIC guarantees that all interface signals ending with the suffix ‘_SYS’ on the system side are disabled when VCC(SYS) goes LOW, protecting the ASIC I/O signals from exceeding its local VDD. In this mode, even if VCC(5V0) is powered, HDMI_5V0_CON goes active and hot plug events can be detected only when the ASIC power supply rail is on. Strapping ACTIVE = VCC(5V0) is the most basic configuration where the buffers are enabled whenever the local VCC(5V0) and VCC(SYS) supplies reach minimum operating levels. Table 10. IP4787CZ32 operating modes VCC(SYS) VCC(5V0) ACTIVE[1] Mode Description < 1.1 V < 4.5 V X Standby mode all outputs high-ohmic 1.1 V 4.5 V L CEC Standby mode CEC circuit active; all other outputs high-ohmic H full operating mode all functional blocks active |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |