LXT974BHC datasheet(21/74 Pages) INTEL

21 / 74 page

Fast Ethernet 10/100 Quad Transceivers — LXT974/LXT975

Datasheet

Only a transformer (1:1 on receive side, 2:1 on transmit side), load resistors, and bypass capacitors

are needed to complete this interface. Using Intel’s patented waveshaping technology, the

transmitter pre-distorts the outgoing signal to reduce the need for external filters for EMI

compliance.

A 4k

Ω passive load is always present across the twisted-pair inputs. When enabled, the twisted-

pair inputs are actively biased to approximately 2.8V.

2.2.1.2

Fiber Interface

The LXT974/975 provides a PECL interface that complies with the ANSI X3.166 specification.

This interface is suitable for driving a fiber-optic coupler.

The twisted-pair pin assignments are remapped to support the PECL interface. The LXT974

supports both the twisted-pair and fiber interface on all four ports. The LXT975, optimized for TP

operation with dual-high RJ-45 connectors, provides dual interfaces on ports 1 and 3.

During 100BASE-FX operation, the FIBI pins receive differential PECL signals and the FIBO pins

produce differential PECL output signals.

Fiber ports cannot be enabled via auto-negotiation; they must be enabled via the Hardware Control

Interface or MDIO registers.

2.2.2

MII Interface

The LXT974/975 supports four standard MIIs (one per port). This interface consists of a data

interface and a management interface. The MII Data Interface passes data between the LXT974/

975 and one or more Media Access Controllers (MACs). Separate signals are provided for

transmit and receive. This interface operates at either 10 Mbps or 100 Mbps. The speed is set

automatically, once the operating conditions of the network link have been determined.

Nine signals are used to pass received data to the MAC: RXD<3:0>, RX_CLK, RX_DV, RX_ER,

COL and CRS. Seven signals are used to transmit data from the MAC: TXD<3:0>, TX_CLK,

TX_EN, and TX_ER.

2.2.2.1

MII Data Interface

Figure 6 shows the data portion of the MII interface. Separate channels are provided for

transmitting data from the MAC to the LXT974/975 (TXD), and for receiving data (RXD) from the

line.

Each channel has its own clock, data bus, and control signals. The LXT974/975 supplies both

clock signals as well as separate outputs for carrier sense and collision. Data transmission across

the MII is implemented in 4-bit-wide nibbles.

Tristating the MII

The LXT974/975 asserts RX_DV, RXD, RX_CLK and RX_ER as soon as it receives a packet from

the network. When TRSTEn is High, the associated port output signals are tristated.

LXT974BHC датащи(PDF) 21 Page - Intel Corporation