CFA633-RDI-KU datasheet(29/86 Pages) CRYSTAIFONTZ

29 / 86 page

Crystalfontz America, Inc.

Data Sheet Release Date 2012/02/21

www.crystalfontz.com

CFA633-RDI-KU LCD Module (Hardware v2.0 / Firmware u2v1)

February 2012

Page 29

USB HOST AND POWER CONNECTIONS

To download and install the FTDI USB certified driver for Vista, XP, or a Mac operating system, follow the three-step

installation instructions here: http://www.crystalfontz.com/software/usb/index.html.

See also CrystalControl2 software here: http://www.crystalfontz.com/product/CrystalControl2.

USB Connection to Host

In order to keep the CFA633-RDI-KU as thin as possible, the CFA633-RDI-KU uses a very low profile 2 mm latching

polarized connector for USB connection. Crystalfontz offers two cables that make the connection between the

CFA633-RDI-KU and the host. The WRUSBY03 (6-foot) has the mating 2 mm connector on one end and a standard

“USB A” on the other end. The WRUSBY11 (27-inch) has the mating 2 mm connector on one end and standard single

pin connectors on the opposite end. These single pin connectors are suitable to plug directly onto the USB headers

typically found on motherboards.

If you would like to make your own cable, the connector on the CFA633-RDI-KU is:

FCI/Berg 95000-004: SMT 2mm connector, 4-position, polarized

The mating housing and crimping contact for the cable are:

FCI/Berg 90312-004: Housing, 2 mm connector, 4-position, polarized

FCI/Berg 77138-001: Crimping Contact (4 pieces required)

FAN CONNECTIONS

The CFA633-RDI-KU supports up to 4 standard “3-pin” cooling fans. The fan connectors are compatible with industry

standard “3-pin” fans.

Figure 11. Four Fan Connectors

c 2010

America, Inc.

Crystalfontz

FAN2

FAN1

J_DOW

J_PWR

TACH

GND

PWR

TACH

FAN3

FAN4

PWR

CFA633-RDI-KU датащи(PDF) 29 Page - Crystalfontz America, Inc.