PI5C3309 datasheet(2/3 Pages) PERICOM

2 / 3 page

PS8330C

01/11/01

12345678901234567890123456789012123456789012345678901234567890121234567890123456789012345678901212345678901234567890123456789012123456789012

PI5C3309

3:1 Mux/Demux BusSwitch

Maximum Ratings

(Above which the useful life may be impaired. For user guidelines, not tested.)

Note

Stresses greater than those listed under MAXIMUM

RATINGS may cause permanent damage to the device.

This is a stress rating only and functional operation of

the device at these or any other conditions above those

indicated in the operational sections of this specifica-

tion isnot implied. Exposure to absolute maximum rating

conditions for extended periods may affect reliability.

DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)

Parameters Description

Test Conditions(1)

Min.

Typ(2)

Max.

Units

VIH

Input HIGH Voltage

Guaranteed Logic HIGH Level

2.0

VIL

Input LOW Voltage

Guaranteed Logic LOW Level

–0.5

0.8

IIH

Input HIGH Current

VCC = Max., VIN = VCC

±1

µA

IIL

Input LOW Current

VCC = Max., VIN = GND

±1

µA

IOZH

High Impedance Output Current

≤IN, YN ≤VCC

±1

µA

VIK

Clamp Diode Voltage

VCC = Min., IIN = –18mA

–0.7

–1.2

IOS

Short Circuit Current(3)

I (Y) = 0V, Y (I) = VCC

100

Input Hysteresis at Control Pins

150

RON

Switch On Resistance(4)

VCC = Min., VIN = 0.0V,

ION = 48mA

Ω

VCC = Min., VIN = 2.4V,

ION = 15mA

Capacitance (TA = 25°C, f = 1 MHz)

Parameters(5)

Description

Test Conditions

Typ

Units

CIN

Input Capacitance

VIN= 0V

COFF

IA Capacitance, Switch Off

VIN= 0V

CON

IA Capacitance, Switch On

VIN= 0V

Notes:

1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at Vcc = 5.0V, TA = 25°C ambient and maximum loading.

3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.

4. Measured by the voltage drop between I and Y pin at indicated current through the switch. ON resistance is determined

by the lower of the voltages on the two (I,Y) pins.

5. This parameter is determined by device characterization but is not production tested.

Storage Temperature ............................................................. –65°C to +150°C

Ambient Temperature with Power Applied ............................. –40°C to +85°C

Supply Voltage to Ground Potential (Inputs & Vcc Only) ....... –0.5Vto+7.0V

Supply Voltage to Ground Potential (Outputs & D/O Only) .... –0.5Vto+7.0V

DC Input Voltage ..................................................................... –0.5Vto+7.0V

DC Output Current ............................................................................... 120mA

Power Dissipation ................................................................................... 0.5W

PI5C3309 датащи(PDF) 2 Page - Pericom Semiconductor Corporation

PI5C3309 датащи(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3

датащи скачать

ссылки URL