74ACT16623 datasheet(3/7 Pages) TI

3 / 7 page

54ACT16623, 74ACT16623

16-BIT BUS TRANSCEIVERS

WITH 3-STATE OUTPUTS

SCAS152A – JANUARY 1991 – REVISED APRIL 1996

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

logic diagram (positive logic)

2B1

2A1

2OEAB

2OEBA

1B1

1A1

1OEAB

1OEBA

To Seven Other Channels

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage range, VCC

–0.5 V to 7 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1)

–0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, VO (see Note 1)

–0.5 V to VCC + 0.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input clamp current, IIK (VI < 0 or VI > VCC)

±20 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC)

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND

±400 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Maximum power package dissipation at TA = 55°C (in still air) (see Note 2): DL package

1.2 W

. . . . . . . . . . .

Storage temperature range, Tstg

–65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

2. The maximum package power dissipation is calculated using a junction temperature of 150

°C and a board trace length of 750 mils.

recommended operating conditions (see Note 3)

54ACT16623

74ACT16623

UNIT

MIN

NOM

MAX

MIN

NOM

MAX

UNIT

VCC

Supply voltage (see Note 4)

4.5

5.5

4.5

5.5

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Input voltage

VCC

Output voltage

VCC

IOH

High-level output current

–24

IOL

Low-level output current

∆t/∆v

Input transition rise or fall rate

ns/V

Operating free-air temperature

–55

125

–40

°C

NOTES:

3. Unused inputs should be connected to VCC through a pullup resistor of approximately 5 kΩ or greater.

4. All VCC and GND pins must be connected to the proper power supply.

PRODUCT PREVIEW information concerns products in the formative or

design phase of development. Characteristic data and other

specifications are design goals. Texas Instruments reserves the right to

change or discontinue these products without notice.

74ACT16623 датащи(PDF) 3 Page - Texas Instruments

74ACT16623 датащи(HTML) 3 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7

датащи скачать

ссылки URL