GD25B64CSIG datasheet(35/57 Pages) GIGADEVICE

35 / 57 page

3.3V Uniform Sector

Dual and Quad Serial Flash

GD25B64C

The command sequence is shown in Figure30. The Read Identification (RDID) command is terminated by driving CS# high

at any time during data output. When CS# is driven high, the device is in the Standby Mode. Once in the Standby Mode,

the device waits to be selected, so that it can receive, decode and execute commands.

Figure 30. Read Identification ID Sequence Diagram

7.27.

High Performance Mode (HPM) (A3H)

The High Performance Mode (HPM) command must be executed prior to Dual or Quad I/O commands when

operating at high frequencies (see fR and fC1 in AC Electrical Characteristics). This command allows pre-charging of

internal charge pumps so the voltages required for accessing the flash memory array are readily available. The

command sequence: CS# goes lowSending A3H command Sending 3-dummy byteCS# goes high. After the

HPM command is executed, HFP bit of status register will be set to 1, the device will maintain a slightly higher standby

current (Icc9) than standard SPI operation. The Release from Power-Down or HPM command (ABH) can be used to

return to standard SPI standby current (Icc1). In addition, Power-Down command (B9H) will also release the device

from HPM mode back to standard SPI standby state.

Figure 31. High Performance Mode Sequence Diagram

CS#

SCLK

9 10

MSB

18 19 20 21

22 23

26 27 28 29

30 31

Capacity

JDID7-JDID0

CS#

SCLK

MSB

Memory Type

JDID15-JDID8

11 12 13 14 15

9FH

Manufacturer ID

MSB

Command

A3H

CS#

SCLK

29 30 31

MSB

3 Dummy Bytes

23 22

High Performance Mode

HPM

GD25B64CSIG датащи(PDF) 35 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25B64CSIG датащи(HTML) 35 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

датащи скачать

ссылки URL