TDA7406T datasheet(29/49 Pages) STMICROELECTRONICS

29 / 49 page

29/49

TDA7406T

4.2 2.2. InGain + InFilter

The InGain stage allows to adjust the MPX-signal to an internal magnitude of about 1Vrms which is the recom-

mended value. The 4.th order input filter has a corner frequency of 80kHz and is used to attenuate spikes and

noise and acts as an anti-aliasing filter for the following switch capacitor filters.

4.3 Demodulator

In the demodulator block the left and the right channel are separated from the MPX-signal. In this stage also the

19-kHz pilot tone is cancelled. For reaching a high channel separation the TDA7406T offers an I

2C-bus pro-

grammable roll-off adjustment which is able to compensate the lowpass behavior of the tuner section. If the tun-

er's attenuation at 38kHz is in a range from 7.2% to 31.0% the TDA7406T needs no external network in front of

the MPX-pin. Within this range an adjustment to obtain at least 40dB channel separation is possible. The bits

for this adjustment are located together with the fieldstrength adjustment in one byte. This gives the possibility

to perform an optimization step during the production of the car radio where the channel separation and the field-

strength control are trimmed. The setup of the Stereoblend characteristics which is programmable in a wide

range is described in 4.8.

4.4 De-emphasis and Highcut

The de-emphasis-lowpass allows to choose a time constant between 37.5 and 100µs. The highcut control range

will be 2 x

τDeemp or 2.7 x τDeemp dependent on the selected time constant (see programming section). The bit

D7 of the hightcut-byte will shift time constant and range.

Inside the highcut control range (between VHCH and VHCL) the LEVEL signal is converted into a 5 bit word

which controls the lowpass time constant between

τDeemp...3 (3.7) x τDeemp. Thereby the resolution will remain

always 5 bits independently of the absolute voltage range between the VHCH- and VHCL-values. In addition

the maximum attenuation can be fixed between 2 and 10dB.

The highcut function can be switched off by I

2C-bus (bit D7, Highcut byte set to “0”).

The setup of the highcut characteristics is described in 4.9.

4.5 PLL and Pilot tone-Detector

The PLL has the task to lock on the 19kHz pilot tone during a stereo-transmission to allow a correct demodula-

tion. The included pilot tone-detector enables the demodulation if the pilot tone reaches the selected pilot tone

threshold VPTHST. Two different thresholds are available. The detector output (signal STEREO, see Block dia-

gram) can be checked by reading the status byte of the TDA7406T via I2C-bus. During a Softmute the PLL can

be set into “Hold”-mode which freezes the PLL's state (bit D4, Softmute byte). After releasing the Softmute the

PLL will again follow the input signal only by correcting the phase error.

4.6 Fieldstrength Control

The fieldstrength input is used to control the highcut- and the stereoblend-function. In addition the signal can be

also used to control the noiseblanker thresholds and as input for the multipath detector. These additional func-

tions are described in sections 5.3 and 6.

4.7 LEVEL-Input and -Gain

To suppress undesired high frequency modulation on the highcut- and stereoblend-control signal the LEVEL

signal is lowpass filtered firstly. The filter is a combination of a 1.st-order RC-lowpass at 53kHz (working as anti-

aliasing filter) and a 1.st-order switched-capacitor-lowpass at 2.2kHz. The second stage is a programmable gain

stage to adapt the LEVEL signal internally to different IF-devices (see Testmode section 5: LEVELHCC). The

gain is widely programmable in 16 steps from 0dB to 6dB (step=0.4dB). These 4 bits are located together with

the Roll-Off bits in the “Stereodecoder-Adjustment”-byte to simplify a possible adjustment during the production

of the car radio. This signal controls directly the Highcut stage whereas the signal is filtered again (fc=100Hz)

before the stereoblend stage (see fig. 24).

TDA7406T датащи(PDF) 29 Page - STMicroelectronics

TDA7406T датащи(HTML) 29 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

датащи скачать

ссылки URL