DS1244/DS1244P

256k NV SRAM

with Phantom Clock

www.artschip.com

2

ORDERING INFORMATION

PART

PIN-PACKAGE

TEMP RANGE

TOP MARK

DS1244Y-70

28-Module (740 mil)

0

℃ to +70℃

DS1244Y-70

DS1244YP-70

34-PowerCap*

0

℃ to +70℃

DS1244YP-70

DS1244W-120

28-Module (740mil)

0

℃ to +70℃

DS1244W-120

DS1244W-120IND

28-Module (740mil)

-40

℃ to +85℃

DS1244W-120IND

DS1244WP-120

34-PowerCap*

0

℃ to +70℃

DS1244WP-120

DS1244WP-120IND

34-PowerCap*

-40

℃ to +85℃

DS1244WP-120IND

*DS9034PCX (PowerCap) Required. (Must be ordered separately.)

DESCRIPTION

The DS1244 256k NV SRAM with a Phantom clock is a fully static nonvolatile RAM (NV SRAM) (organized as 32k words by 8 bits)

with a built-in real-time clock. The DS1244 has a self-contained lithium energy source and control circuitry, which constantly

monitors Vcc for an out-of-tolerance condition. When such a condition occurs, the lithium energy source is automatically switched

on and write protection is unconditionally enabled to prevent garbled data in both the memory and real-time clock.

The phantom clock provides timekeeping information for hundredths of seconds, seconds, minutes, hours, days, date, months,

and years. The date at the end of the month is automatically adjusted for months with fewer than 31 days, including correction for

leap years. The phantom clock operates in either 24-hour or 12-hour format with an AM/PM indicator.

PACKAGES

The DS1244 is available in two packages: 28-pin DIP and 34-pin PowerCap module. The 28-pin DIP style module integrates the

crystal, lithium energy source, and silicon all in one package. The 34-pin PowerCap module board is designed with contacts for

connection to a separate PowerCap (DS9034PCX) that contains the crystal and battery. This design allows the PowerCap to be

mounted on top of the DS1244P after the completion of the surface mount process. Mounting the PowerCap after the surface

mount process prevents damage to the crystal and battery due to the high temperatures required for solder reflow. The PowerCap

is keyed to prevent reverse insertion. The PowerCap module board and PowerCap are ordered separately and shipped in

separate containers. The part number for the PowerCap is DS9034PCX.

RAM READ MODE

The DS1244 executes a read cycle whenever

(write enable) is inactive (high) and

(chip enable) is active (low). The

unique address specified by the 15 address inputs (A0-A14) defines which of the 32,768 bytes of data is to be accessed. Valid

and

(output enable) access times and states are also satisfied. If

and

access times are not satisfied, then data

access must be measured from the later occurring signal (

or

, rather than address access.

RAM WRITE MODE

The DS1244 is in the write mode whenever the

and

signals are in the active (low) state after address inputs are stable.

The latter occurring falling edge of

or

will determine the start of the write cycle. The write cycle is terminated by the

earlier rising edge of

or

. All address inputs must be kept valid throughout the write cycle.

must return to the high

control signal should be kept inactive (high)

during write cycles to avoid bus contention. However, if the output bus has been enabled (

and

active) then

will