CS42406 datasheet(45/50 Pages) CIRRUS

45 / 50 page

CS42406

Zero Cross

Zero Cross Enable dictates that signal level changes, either by attenuation changes or muting, will

occur on a signal zero crossing to minimize audible artifacts. The requested level change will occur

after a timeout period between 512 and 1024 sample periods (10.7 ms to 21.3 ms at 48 kHz input

sample rate) if the signal does not encounter a zero crossing. The zero cross function is independent-

ly monitored and implemented for each channel.

Soft Ramp

Soft Ramp allows level changes, both muting and attenuation, to be implemented by incrementally

ramping, in 1/8 dB steps, from the current level to the new level at a rate of 1 dB per 8 DAC_LRCK

periods.

Soft Ramp and Zero Cross

Soft Ramp and Zero Cross dictates that signal level changes, either by attenuation changes or mut-

ing, will occur in 1/8 dB steps and will be implemented on successive signal zero crossings. The 1/8

dB level changes will occur after timeout periods between 512 and 1024 sample periods (10.7 ms to

21.3 ms at 48 kHz input sample rate) if the signal does not encounter zero crossings. The zero cross

function is independently monitored and implemented for each channel.

6.5.2

CONTROL PORT ENABLE (CPEN) BIT 5

Default = 0

0 - Disabled

1 - Enabled

Function:

The Control Port will become active and reset to the default settings when this function is enabled.

6.5.3

POWER DOWN (PDN) BIT 4

Default = 1

0 - Disabled

1 - Enabled

Function:

The DAC will enter a low-power state when this function is enabled, but the contents of the control

registers will be retained in this mode. The power-down bit defaults to ‘enabled’ on power-up and must

be disabled before normal operation in Control Port mode can occur.

6.5.4

POPGUARD® TRANSIENT CONTROL (POPG) BIT 3

Default = 1

0 - Disabled

1 - Enabled

Function:

The PopGuard® Transient Control allows the quiescent voltage to slowly ramp to and from 0 volts to

the quiescent voltage during power-on or power-off when this function is enabled. Please see section

4.7 for implementation details.

CS42406 датащи(PDF) 45 Page - Cirrus Logic

CS42406 датащи(HTML) 45 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

датащи скачать

ссылки URL