14W HI-FI AUDIO AMPLIFIER

TDA2003(C)

 

第 6 页  共 11 页 

BUILT-IN PROTECTION SYSTEMS

LOAD DUMP VOLTAGE SURGE

The TDA2003 has a circuit which enables it to withstand a voltage pulse train, on pin 5.If the supply voltage

peaks to more than 40V, then an LC filter must be inserted between the supply and pin 5, in order to assure that

the pulses at pin 5 will be head within the limits.

A recommended LC network. With this network, a train of pulses with amplitude up to 120V and width of 2ms

can be applied at point A. This type of protection is ON when the supply voltage(pulsed or DC) exceeds 18V. For

this reason the maximum operating supply voltage is 18V.

The TDA2003 can withstand a permanent short-circuit on the output for a supply voltage up to 16V.

POLARITY INVERSION

High current (up to 5A) can be handled by the device with no damage for a longer period than the blow-out

time of a quick 1A fuse(normally connected in series with the supply).

The feature is added to avoid destruction if, during fitting to the car, a mistake on connection of the supply is

made.

OPEN GROUND

When the radio is in the ON condition and the ground is accidentally opened, a standard audio amplifier will

be damaged. On the TDA2003 protection diodes are included to avoid any damage.

INDUCTIVE LOAD

A protection diode is provide between pin 4 and pin 5(see the internal schematic diagram) to allow use of the

TDA2003 with inductive loads. In particular, the TDA2003 can drive a coupling transformer for audio modulation.

DC VOLTAGE

The maximum operating DC voltage on the TDA2003 is 18V. However the device can withstand a DC

voltage up to 28V with no damage. This could occur during winter if two batteries were series connected to crank

the engine.