| поискавой системы для электроныых деталей |
|
TMP141 датащи(PDF) 12 Page - Texas Instruments |
|
|
|
|||||||||||||||||||||||||||||
TMP141 датащи(HTML) 12 Page - Texas Instruments |
|
12 / 19 page ![]() TMP141 SBAS347 − MARCH 2005 www.ti.com 12 Register Ah: Temperature Control (Read/Write) Bits 15−2: Reserved. These bits read as ‘0’. Bit 1, Enable Sensor (EN_S): Default is ‘0’, which is the disabled state. In addition to setting this bit, the enable bit in register 5 must also be set in order to measure temperature. Bit 0, Attention Enable (AT_E): Default is disabled. When this bit is set, and the sensor is enabled (bit 1), the TMP141 will generate Attention Requests. If enabled, an Attention Request will be generated when a bit is set in the Device Status register (register 4). See Figure 5 for the details on the conditions for generating an Attention Request. Note: A bus error always attempts to generate an Attention Request. (For more information on the Attention Request conditions, see the flowcharts in Figure 4 and Figure 5, and the information on Exception Handling on page 14.) The rules for generating an Attention Request are different, depending on whether it was caused by a bus error or a temperature conversion. A bus error always attempts to generate an Attention Request, whereas a conversion or a conversion overrun has several conditions that may prevent the assertion of Attention Request. These differences are illustrated in Figure 4 and Figure 5. Register 20h: Conversion Rate (Read/Write) The conversion rate is controlled by both the low-power bit in the Device Control register, and the Conversion Rate setting in the Conversion Rate register. This register is device-specific, and therefore not defined by the SensorPath specification. The conversion rate for a given application is chosen based on system requirements and limitations, such as the thermal response time of the system (including the TMP141). Table 4. Conversion Time Settings LOW-POWER MODE (register 5, bit 2) CONVERSION RATE SETTING (register 20h, bits 1−0 binary) TYPICAL CONVERSION TIME (ms) 0 00 64 1 00 96 0 01 96 1 01 382 0 10 190 (default) 1 10 766 0 11 382 1 11 1532 |
|
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |