5

Metal Line Switches

MSM CS 22

https://www.schurter.com /PG70

Switches

Dimension

MSM 22 CS ST

Drilling diagram

MSM 22 CS LE / MSM 22 CS BL

Drilling diagram

Assembly Instructions

During assembly, the protruding bars of the holder should not be pressed together.

I Housing

II Flat Pin Terminal (Illumination)

III Gasket

IV Nut (Nut type see Dimensions)

V Module Switching Contact

Installation Instruction:

1.) Place the gasket accurately on the actuator housing. Then mount the actuator housing assembly into the panel.

2.) Tighten the screw nut according to the torque instructions.

3.) Clasp the module switching contact into the micro switch holder of the actuator housing.

Installation information:

1.) The power supply and the configuration of the flat pin terminals have to be installed correctly for the illumination and micro switch function.

2.) Insulate the terminals as required. Fully insulated plug-in sleeves are recommended.

3.) Installation instructions according to VDE-standard DIN VDE 0100-100 or alternatively IEC 60354 standard.