LTM4677 datasheet(20/34 Pages) LINER

20 / 34 page

LTM4647

4647fb

For more information www.linear.com/LTM4647

APPLICATIONS INFORMATION

The LTM4647 has been designed to effectively remove

heat from both the top and bottom of the package. The

bottom substrate material has very low thermal resistance

to the printed circuit board. An external heat sink can be

applied to the top of the device for excellent heat sinking

with airflow.

Figures10and11showthethermalimagesoftheLTM4647

with no heat sink and no airflow and 200LFM airflow with

4.7W of internal dissipation.

Safety Considerations

The LTM4647 modules do not provide isolation from VIN

to VOUT. There is no internal fuse. If required, a slow blow

fuse with a rating twice the maximum input current needs

tobeprovidedtoprotecteachunitfromcatastrophicfailure.

The fuse or circuit breaker should be selected to limit the

current to the regulator during overvoltage in case of an

internal top MOSFET fault. If the internal top MOSFET fails,

then turning it off will not resolve the overvoltage, thus

the internal bottom MOSFET will turn on indefinitely trying

to protect the load. Under this fault condition, the input

voltage will source very large currents to ground through

the failed internal top MOSFET and enabled internal bot-

tom MOSFET. This can cause excessive heat and board

damage depending on how much power the input voltage

can deliver to this system. A fuse or circuit breaker can be

used as a secondary fault protector in this situation. The

device does support over current protection. The TEMP+

and TEMP– pins are provided for monitoring internal tem-

perature, and can be used to detect the need for thermal

shutdown that can be done by controlling the HIZB pin.

Output Current Derating

The 1V, 1.5V power loss curves in Figures 12 to 13 can

be used in coordination with the load current derating

curves in Figures 14 to 21 for calculating an approximate

θJA thermal resistance for the LTM4647 with various heat

sinking and airflow conditions. The power loss curves

are taken at room temperature and are increased with a

multiplicativefactoraccordingtothejunctiontemperature,

which is 1.3 for 120°C. The derating curves are plotted

with the output current starting at 30A and the ambient

temperature at ~40°C. The output voltages are 1V and

1.5V. These are chosen to include the lower and higher

outputvoltagerangesforcorrelatingthethermalresistance.

Thermal models are derived from several temperature

measurementsinacontrolledtemperaturechamberalong

withthermalmodelinganalysis.Thejunctiontemperatures

are monitored while ambient temperature is increased

with and without airflow. The power loss increase with

Figure 10. LTM4647 12VIN to 1VOUT at 30A with No Air Flow

and No Heat Sink

4647 F10

Figure 11. LTM4647 12VIN to 1VOUT at 30A with 200LFM

Air Flow and No Heat Sink

4647 F11

LTM4677 датащи(PDF) 20 Page - Linear Technology

LTM4677 датащи(HTML) 20 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34

датащи скачать

ссылки URL