LE AB H3AB

2008-07-07

13

Connecting and disconnecting OSRAM OS Ostar Projection modules

When connecting or disconnecting an Ostar Projection module care has to be taken in order to prevent

a damage of the module. The module is equipped with a male connector socket (JST SM 10B-SR

SS-TB). As a female connector for power supply a JST SHR-10V-S (without protrusions) or a JST

SHR-10V-S-B (with protrusions) with SSH-003T-P0.2 pins is recommended.

When disconnecting the connector the applied pull force must not exceed 17 N * (footnote * A force of

17 N can only be applied dynamically during disconnecting. No constant force must be applied to the

connector.) Disconnection of the module during operation or at high temperatures can damage the

module. The board temperature must not exceed 40°C during disconnection. During mating operation,

mate connectors while holding wires in a bundle on the same axis to the mating axis. For unmating wires

must be held in a bundle within 20 degrees to the mating axis (see Fig. for explanation).

OHO03020

PCB

Connector

PCB

Connector

Wire

20˚

20˚

20˚

Wire