SPDT RF Switch

JSW2-63DR+

Page 4 of 6

Notes

A. Performance and quality attributes and conditions not expressly stated in this specification document are intended to be excluded and do not form a part of this specification document.

B. Electrical specifications and performance data contained in this specification document are based on Mini-Circuit’s applicable established test performance criteria and measurement instructions.

C. The parts covered by this specification document are subject to Mini-Circuits standard limited warranty and terms and conditions (collectively, “Standard Terms”); Purchasers of this part are entitled

to the rights and benefits contained therein. For a full statement of the Standard Terms and the exclusive rights and remedies thereunder, please visit Mini-Circuits’ website at www.minicircuits.com/MCLStore/terms.jsp

Parameter

Ratings

Operating Temperature

-40°C to +85°C

Storage Temperature

-55°C to 125°C

V

5.0V

Voltage Control

RF input power

State of:

RF Common to

Control Voltage

Enable Voltage

RF1

RF2

High

High

ON

OFF

Low

High

OFF

ON

Low/High

Low

Shutdown

ON- low insertion loss state OFF- Isolation State

5. Operation of this device above any of these conditions may cause permanent damage.

6. Derate linearly to 2.5W at 85°C.

Characterization Test Circuit

Test Equipment:

For Insertion loss, Isolation, Return loss:

Agilent’s N5230A Network Analyzer , E3631A power supply.

For Switching Time and Video Feed through

Agilent’s AG54832B HP81110A pulse generator, HPE3631A Network Analyzer , E3631A power supply.

Agilent’s N90A Spectrum Analyzer , E8257D Generator U200A

For Compression:

R&S Network Analyzer ZVA24, E3631A power supply.

Conditions:

V

For Insertion loss, isolation and return loss: Pin=0 dBm

For Input IP3: Pin=+10dBm/tone.

For Switching time: RF frequency: 500 MHz at 0 dBm, Control Frequency: 10 KHz and 0 and +1.65V.

Figure 1: Block Diagram Of Test Circuit Used For Characterization.

(DUT soldered on Mini-Circuit’s TB-725+)