CP10.241-R1, CP10.241-R2,

CP10.241-R3,CP10.242-R2

CP-Series

Feb. 2018 / CP10.241-R2 Rev0.3-EN - All values are typical figures specified at 230Vac, 50Hz input voltage, 24V, 10A output

load, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

20/31

P R E L I M I N A R Y

The output voltage is floating and has no ohmic connection to the ground. Type and routine tests are conducted by

the manufacturer. Field tests may be conducted in the field using the appropriate test equipment which applies the

voltage with a slow ramp (2s up and 2s down). Connect all input-terminals together as well as all output poles before

conducting the test. When testing, set the cut-off current settings to the value in the table below.

Fig. 19-1 Dielectric strength

A

B

C

D

Type test

60s

2500Vac

4000Vac

1000Vac

500Vac

Routine test

5s

2500Vac

2500Vac

500Vac

500Vac

Field test

5s

2000Vac

2000Vac

500Vac

500Vac

Cut-off current setting

for field test

> 10mA

> 10mA

> 20mA

> 1mA

AD

C

N

L

Input

DC-ok

Earth, PE

Output

-

+

It is recommend that either the + pole, the – pole or any other part

of the output circuit shall be connected to the earth/ground system.

This helps to avoid situations in which a load starts unexpectedly or

can not be switched off when unnoticed earth faults occur.

B*) When testing input to DC-OK ensure that the maximal voltage between DC-OK and the output is not exceeded (column D). We

recommend connecting DC-OK pins and the output pins together when performing the test.